Craftsman 358795790 Operation Manual - Page 10

¢_. @I_I_A'_I_G _lfnOtq -- F_m'e 11 a. Before s_ng the Engine, stand as shown in Figure [0 and check for the following: 1) Left arm fully extended, hand holding Assist Handle. 2). Right arm slightly bent, hand holding the Foam Grip, fingers on Throttle Trigger ,3). Engine below waist level 4) Weight of tool evenly distributed between arms 5) Without operator bending over, the Trimmer Head is near and parallel to the ground and easily contacts the material to be cut b Adjust the Assist HMndle up or down the Drive Shaft Housing (but above the Safety Label) to a comfortable position I) Loosen the Wing Nut by hand, adjust Assist Handle, Retighten Wing Nut by hand only 2)_ Rotate the Assist Handle from left to right if it is necessary, to tilt the angle of the Trimmer Head such as when cutting a large, sloped area such as a ditch bank. RIGHTARM SLIGHTLY BENT, HAND HOLDING FOAM GRIP. FINGERS ON TRIGGER \ THROTTLE ! "-.._ ENGINE IS BELOW VvAlSq- [ EVEr FACESHIELD tEl:q" ARM EXTENDED HAND HOLDING ASSIST HANDI E I RIMMER HEAD tS NEAR THE GROUND AND EASILY CONTACTS Figure 11 ACC g F The following accessories are available through Sears Retail Stores, Catalog, Outlets or Service Centers ITEM Safety Face Shield Safety Goggles 2-Cycle Engine Oil Spark Plug Fuel Cap Replacement Trimmer Head (available only through Sears Service Centers) Replacement Nylon Trimmer Line -- 400 ft -- 200 ft Replacement Spool with Line Flex Shaft Lube Shoulder Strap Kit Spark Arrestor Kit Operator's Manual SqOC K NO. 9-I86L3 9-1859 71-36555 71-86555 71-79705 71-85860 71-85778 71-85608 71-85810 530-030102 71-85783 952-701612 530-067315 10