Craftsman 358795790 Operation Manual - Page 8
F gure
View all Craftsman 358795790 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
[_u'rloN:] Do not bend the throttle cable° a, Slide the Throttle Trigger Housing from the Foam Grip about 1" to 1-t/2" bo Insert the Throttle Cable through the tunnel in the Foam Grip until the end of the Cable extends at least 2 inches beyond the Grip, Figure 2 c Hold the Tl,igger away from the Drive Shaft Housing and insert the barrel end of the Throttle Cable into the round opening in the Trigger as shown in Figures 2 & 3 d Push the Trigge_ back into the Housing while guiding the Cable through the split in the arm (Figure 3) Guide the arm into the Foam Grip tunnel while replacing the Throttle Trigger Housing flush against the Grip e Squeeze Trigger against the Foam Grip before installing Screw and Nut Figure 4_ See Caution below [CAU'rlON:I Do not overtighten screw. Make sure trigger vdll move freely, There must be at least 1/8" free play in the trigger. Figure 5. 3. A_I_T HANDI_ -- F_s 6 If your unit is equipped with Assist Handle A (See Carton Contents section) proceed to the 'Assist Handle A" section, If your unit is equipped with Handle B (see Carton Contents Section), proceed to the "Assist Handle B" section ASSIST HANDLE A a Align the Assist Handle above the Safety Label and below the Throttle Trigger, Figure 6, b Firmly push the Assist Handle over the Drive Shaft Housing while supporting the Drive Shaft Housing c Insert the Assist Handle Screw through the screw hole in the Assist Handle Figure 6 d Place Washer over the threaded end of the Assist Handle Screw Thread Wing Nut onto Assist Handle Screw Tighten securely, [CAu'IrloN:] When adjusting the Assist Handle for comfort, be sure that the Assist Han* die remains between the Throttle 'lYigger Housing and the Safety Label on Drive Shaft Housing. ASSKST _--_NDLE B a Insert the end of the Drive Shaft Housing through the Assist Handle Figure 7 (Inset) b. Align the Assist Handle between the safety label and the Throttle Trigger Housing and seat the Drive Shaft Housing in the groove in the Assist Handle Figure 7 ROUND HOLE IN TRIGGER BARREL ENDOF CABLE ARM :c CABLE THROTTLE TRIGGER HOUSING U8 " PLAY F gure 5 TRIGGER SHIEL D ACq_AL SiZE 6 c. Insert the tab on the Assist Handle Bracket into the slot on the Assist Handle Figure 7, Then lay the Assist Handle Bracket over the Drive Shaft d. Insert screw down through the hole in the Assist Handle Biacket and then through the Assist Handle, Figure 7_