Craftsman 3800 Operation Manual - Page 6
Yourpressure, washer, requires, someassembly, isready, foruseonlyafter, ithasbeenproperly, serviced - no pressure . pressure washer
View all Craftsman 3800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Yourpressurweasherrequiressomeassembalyndis ready foruseonlyafteirt hasbeenproperlsyervicewdiththe recommendoeiladndfuel. If you have any problemswith the assembly of your pressurewasher, please call the pressurewasher helpline at 1-800-222-3136. IMPORTANT:Any attempt to run the engine before it has been serviced with the recommended oil will result in an engine failure. 5. Verify pump oil dipstick (A) has been installed into pump. Unpack the Pressure Washer 1. Remove everything from carton except pressure washer. 2. Open carton completely by cutting each corner from top to bottom. 3. Remove pressure washer from carton. Carton Contents Checkall contents. If any parts are missing or damaged,call the pressure washer helpline at 1-888-222-3136. • The main unit • Handle • Spray gun • High pressure hose • Nozzleextension with quick connect fitting • Engine oil • Parts bag (which includes items listed below) • Owner's manual • Registration card • Bagcontaining 5 multi-colored quick connect spray tips • HandleFasteningHardwareKit (which includes): • Carriage Bolt (2) • Plastic Knobs (2) Becomefamiliar with each piece before assembling the pressure washer. Checkall contents against the illustration on page 5. if any parts are missing or damaged, call the pressure washer helpline at 1-888-222-3136. AssembJingYour Pressure Pasher Your Craftsman pressure washer will need assembly before operation: 1. Fill out and send in registration card. 2. Attach handle. 3. Add oil to engine crankcase. 4. Add fuel to fuel tank. 6. Connect pressure hose to spray gun and pump. 7. Connect water supply to pump. 8. Attach nozzle extension to spray gun. 9. Select/attach quick connect spray tip to nozzle extension. Attach HandJe 1. Placehandle (B) onto handle supports (C) connected to main unit. Make sure holes (D) in handle align with holes (D) on handle supports. NOTE:it may be necessary to move the handle supports from side to side in order to align the handle so it will slide over the handle supports. 2. Insert carriage bolts (E) through holes from outside of unit and attach a plastic knob (F) from inside of unit. Tighten by hand. 3. Insert multi-colored spray tips in spaces provided in handle.