Cub Cadet 3X 26 inch INTELLIPOWER Operation Manual - Page 12
Overhead Chute Rotation Control W, Way Electric Pitch & Rotation Control
View all Cub Cadet 3X 26 inch INTELLIPOWER manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
SET-UP 6. Perform one of the following to connect the flex shaft to the chute control rod coupling: • Models with Overhead Rotational - Insert hex end of flex shaft into chute control rod coupling under handle panel (Figure 30). Figure 30 • Models with Electric Chute Control - Insert other end of flex shaft into chute control rod coupling under handle panel. Make sure to line up flat end of rod and flat end of coupler. You may need to rotate rod around until these two surfaces line up (Figure 31 inset). A Non-Hydro Models B Hydro Models Figure 33 4. If necessary, loosen the jam nut (f) and rotate the ferrule up or down on the shift rod until the ferrule aligns with the upper hole in the shift lever (Figure 32). Tighten jam nut. 5. Insert ferrule into top hole of shift lever and secure with cotter pin (a) and washer (b) removed in Step 2. STOP Continue to Set-Up (page 14). OVERHEAD CHUTE ROTATION CONTROL W/ 4-WAY ELECTRIC PITCH & ROTATION CONTROL Chute Assembly Figure 31 Shift Rod (if Equipped) 1. Ensure speed selector is in fastest forward speed. 2. Remove cotter pin (a) and washer (b) from adjustment ferrule (c) on shift rod (d) and pull it out from shift lever (e) (Figure 32 inset). e c a Chute Control Rod or Manual Chute Control Rod f b d Figure 32 3. Make sure the shift lever on the back of the transmission is rotated downward to the full extent of its rotation see Figure 33, Detail "A" for models without hydro transmission or Detail "B" for models with hydro transmission. Figure 34 NOTE: If equipped with a metal chute assembly - This assembly will install the same as the standard chute shown in the figures of this procedure. 12