Cub Cadet 3X 26 inch INTELLIPOWER Operation Manual - Page 6
SET-UP
View all Cub Cadet 3X 26 inch INTELLIPOWER manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
SET-UP OVERVIEW • Remove packaging materials from snow blower and any loose items from the carton. • Rotate Handle into the upright position. Refer to Handle Assembly. • Install the chute. Refer to Chute Assembly Options. • Complete snow blower assembly according to model and equipment. Refer to Set-up. • If necessary make adjustments to ensure proper snow blower operation. Refer to Adjustments. • Add fuel and oil. Refer to the Engine Operator's Manual shipped with snow blower. TOOLS REQUIRED • Adjustable Wrench or Socket Set • Needle Nose Pliers HANDLE ASSEMBLY 1. Cut cable ties securing chute control rod or upper handle to the lower handle (if applicable), set aside the chute control rod (if applicable) and remove the wrap around the handles (if applicable). NOTE: Do not cut the cable tie securing the control cables to the engine, if equipped. NOTE: On models with Overhead Chute Control (with Flex Shaft), Four-Way Chute Control, and Electric Chute Control cut cable ties securing flex shaft to the lower handle and set the flex shaft aside. Remove rubber bands securing cables to carriage bolts and cut cable tie securing shift rod to lower handle. Refer to Figure 7 to help identify the control styles. 2. Loosen the top two nuts (a) securing the upper and lower handle and remove the two carriage bolts (b) from the upper handle and set aside as shown in Figure 1 or Figure 2 for models with side supports. b b a a b Figure 2 IMPORTANT: Place shift lever in Forward-6 position or fastest forward speed (if equipped). 3. Observe lower rear area of equipment to be sure both cables (if equipped) are aligned and seated properly in roller guides (Figure 3). NOTE: On select models, chute-pitch control cables will be routed under the engine on the left side and will not use roller guides. Figure 3 4. Ensuring any cables, and wiring harness are clear of pivot points, Pivot handle upward and align the lower handle (Figure 4). Remove and discard any rubber bands, if present. They are for packaging purposes only. a a Figure 1 b Figure 4 NOTE: On select models with steel rod speed selectors, you may need to lower shift rod to the side slightly to maneuver handle panel over it when pivoting handle upward. 6