Cub Cadet 3X 26 inch INTELLIPOWER Operation Manual - Page 13
Chute, Chute Support Bracket, Chute Base, Chute Control Head, Continue to Set-Up
View all Cub Cadet 3X 26 inch INTELLIPOWER manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
SET-UP 1. Remove cotter pin (a), wing nut (b) and hex screw (c) from chute control head. Remove clevis pin (d) and bow-tie cotter pin (e) from chute support bracket (Figure 35). Chute Control Head Chute Support Bracket dac 121 e Chute Chute Base b Figure 35 NOTE: For smoothest operation, cables should all be to the left of the chute control rod. 2. Insert round end of chute control rod into chute control head. Push rod as far into chute control head as possible, keeping holes in rod pointing upward (Figure 36). c b Figure 38 5. Insert other end of chute control rod into coupler below handle panel. Make sure to line up flat end of rod and flat end of coupler. You may need to rotate rod around until these two surfaces line up (Figure 39 inset). Figure 39 6. Push chute control rod toward the control panel until hole in rod lines up with middle hole in chute control coupler and insert cotter pin (a) removed in Step 1 (Figure 40). Figure 36 3. Place chute onto chute base and ensure chute control rod is positioned above lower handle. Secure chute control head to chute support bracket with clevis pin (d) and bow-tie cotter pin (e) removed in Step 1 (Figure 37). d e Figure 37 4. Finish securing chute control head by installing hex screw (c) and wing nut (b) removed in Step 1 (Figure 38). a Figure 40 NOTE: There is a reference hole provided at rear end of control rod to help know when holes are vertical. NOTE: Hole furthest from chute control head is used to achieve further engagement of chute control rod into coupler under control panel, if required. Refer to Adjustments, Overhead Chute Control on page 16. NOTE: For models equipped with manual chute control rods, the hole closest to chute control head is used for manual movement of chute assembly, if required. Refer to Operation, Manual Chute Rotation Control & Electric Chute Control on page 23. STOP Continue to Set-Up (page 14). 13