Cub Cadet FT 24 Operation Manual - Page 12

Depth Stake The depth stake acts as a brake for the tiller and controls the depth and speed at which the machine will operate. Remove the clevis pin and hairpin clip to raise or lower depth stake. See Fig. 5-3. Tilling Procedure When tilling, leave approximately eight inches of untilled soil between the first and second tilling paths, then make the third path between the first and second, Fig. 5-4. 4 5 2 3 1 Figure 5-3 Handle Pressure Further control of the tilling depth and travel speed can be obtained by variation of pressure on the handles. A downward pressure on the handles will reduce the working depth and increase the forward speed. An upward pressure on the handles will increase the working depth and reduce the forward speed. The type of soil and working conditions will determine the actual setting of the depth stake and the handle pressure required. Transporting and Storing the Tiller To transport and store the tiller move the throttle to the stop position. Pivot the depth stake away from ground up between wheels. See Fig. 5-3. Using Your Tiller Your tiller is designed for seed bed preparation, cultivating, furrowing and mulching. Figure 5-4 In some soils, the desired depth is obtained the first time over the garden. In other soils, the desired depth is obtained by going over the garden two or three times. Passes should be made across the length and width of the garden alternately. Rocks which are turned up should be removed from the garden area. 12 Section 5- Operation