Cub Cadet SC 500 ez SC 500 ez Operator's Manual - Page 15

Maintenance & Adjustments 6 Maintenance General Recommendations • Always observe safety rules when performing any maintenance. • The warranty on this lawn mower does not cover items that have been subjected to operator abuse or negligence. To receive full value from warranty, operator must maintain the lawn mower as instructed here. • Changing of engine-governed speed will void engine warranty. • All adjustments should be checked at least once each season. • Periodically check all fasteners and make sure these are tight. WARNING: Always stop engine, allow engine to cool, disconnect spark plug and ground against engine before performing any type of maintenance on your machine. Lubrication 1. Lubricate pivot points on the blade and drive controls at least once a season with light oil. These controls must operate freely in both directions. See Figure 6-1. Deck Wash Your mower's deck may be equipped with a water port on its surface as part of its deck wash system. Use the deck wash to rinse grass clippings from the deck's underside and prevent the buildup of corrosive chemicals. Complete the following steps AFTER EACH MOWING: 1. Push the mower to a level, clear spot on your lawn, near enough for your garden hose to reach. CAUTION: Make certain the mower's discharge chute is directed AWAY from your house, garage, parked cars, etc. 2. Thread the hose coupler (packaged with your mower's Operator's Manual) onto the end of your garden hose. 3. Attach the hose coupler to the water port on your deck's surface. See Figure 6-2. Figure 6-2 4. Turn the water on. 5. Start the engine as described in the Operation section. 6. Run the engine for a minimum of two minutes, allowing the underside of the cutting deck to thoroughly rinse. 7. Release blade control to stop the engine and blade. Figure 6-1 2. Lubricate the front wheels and casters at least once a season with light oil (or motor oil). If wheels are removed for any reason, lubricate the axle bolt and inner surface of the wheel with light oil. 8. Turn the water off and detach the hose coupler from the water port on your deck's surface. After cleaning your deck, restart the mower. Keep the engine and blade running for a minimum of two minutes, allowing the underside of the cutting deck to thoroughly dry. 3. The transmission is pre-lubricated and sealed at the factory and does not require lubrication. 4. Follow the accompanying engine manual for lubrication schedule and instruction for engine lubrication. 15