Cub Cadet TANK M72-KW TANK M72-KW Operator's Manual - Page 16
Transmission Bypass Valves Not Shown
View all Cub Cadet TANK M72-KW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
Fuel Shut-Off Valve The fuel shut-off valve is located on top of the fuel tank(s). When turned in a clockwise direction until it stops, it will shut off the flow of fuel to the engine. When turned in a counterclockwise direction it will open and allow fuel to flow to the engine. See Fig. 4-2. CLOSE Transmission Bypass Valves (Not Shown) The transmission bypass valves (one for each the RH and LH transmission) are located just in front of the engine and just behind the seat. When engaged, the two valves open a bypass within the hydrostatic transmissions, which allows the tractor to be pushed short distances by hand. Refer to the Maintenance & Adjustments section for instructions on using the bypass feature. Caution: Never tow your tractor. Towing the tractor with the rear wheels on the ground may cause severe damage to the transmissions. OPEN Figure 4-2 NOTE: Close this valve if you are not going to run the mower for a period of 30 minutes or more to prevent flooding the engine. Seat Adjustment Lever (Not Shown) The seat adjustment lever is located below the front/left of the seat. The lever allows for adjustment of the fore to aft position of the operator's seat. Refer to the Maintenance & Adjustments section for instructions on adjusting the seat position. Roll Over Protective System (ROPS) The roll-over protection system is an integral part of you zeroturn tractor. It is designed to create a crush-resistant space for the operator in the event of a roll-over. DANGER! The Roll Over Protection System should not be tampered with, modified or removed. If the system is damaged, it must be replaced prior to operator use. Failure to us the Roll Over Protection System and seat belt properly could result in serious injury or death. Hydrostatic Pumps and Motors The pumps are located behind the seat and are the hardestworking components in the hydraulic system. They are in operation all the time the engine is running. The pumps and motors serve as the sytem that propels the tractor's drive system. Front Skirts The front skirts are located on the front of the deck and help lift the grass for precision cutting or can be raised to allow for the cutting of large volumes of grass. See the Maintenance & Adjustments section for more information on adjusting the front skirt. 16 Section 4- Controls & Features