Cuisinart FP-14 FP-14DC Manual - Page 18
Press the Off
UPC - 086279025609
View all Cuisinart FP-14 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
8. Problem: Dough feels tough after kneading Solution: • Divide dough into 2 or 3 pieces and redistribute evenly in bowl. Process 10 seconds or until uniformly soft and pliable. 9. Problem: Dough is too dry. Solution: • While machine is running, add water, 1 tablespoon at a time until dough cleans the inside of the bowl. 10. Problem: Dough is too wet. Solution: • While machine is running, add flour, 1 tablespoon at a time until dough cleans the inside of the bowl. Technical 1. Problem: The motor does not start. Solution: • There is a safety interlock to prevent the motor from starting if it is not properly assembled. Make sure the work bowl and work bowl cover are securely locked into position. • If you are slicing or shredding and the above solution does not work, make sure that the food contents in the feed tube are cut below the maximum fill line so that the activation rod can engage the motor. • If the motor still will not start, check the power cord and outlet. 2. Problem: The food processor shuts off during operation. Solution: • The cover may have become unlocked; check to make sure it is securely in position. • A safety protector in the motor prevents the motor from overheating, which is caused by excessive strain. Press the Off control button and wait 10 to 15 minutes to allow the food processor to cool off before resuming. 3. Problem: The food processor cover becomes unlatched in the back and or makes a loud noise. Solution: • The back of the cover becoming unlatched, and any related noise, will not prevent the unit from working. Simply push down to lock the back into position. 4. Problem: The motor slowed down during operation. Solution: • This is normal as some heavier loads (e.g. slicing/shredding cheese) may require the motor to work harder. Simply reposition the food in the feed tube and try again. • The maximum load capacity may have been exceeded. Remove some of the ingredients and continue processing. 5. Problem: It is difficult to remove the chopping/mixing blade from the work bowl. Solution: • These innovative blades have been designed to lock in the work bowl to prevent them from falling out when emptying the contents of the bowl. Using extreme care, use a little extra force to remove the blade. 6. Problem: The food processor vibrated/ moved around the countertop during processing. Solution: • Make sure the rubber feet at the bottom of the unit are clean and dry. Also make sure that the maximum load capacity is not being exceeded. • This is normal as some heavier loads (e.g. slicing/shredding cheese) may require the motor to work harder. 7. Problem: The large pusher falls out when the cover is turned upside down. Solution: • The pusher lock feature, located above the handle, should be pulled out. 18