Cuisinart SS-15 Owner Manual - Page 11

SETTING UP YOUR SINGLE-SERVE COFFEEMAKER INITIAL CLEANING Perform an initial cleaning before making your first beverage. Follow these instructions, without inserting a capsule. 1. Insert charcoal water filter if you haven't already. Instructions on page 8. 2. Remove water reservoir from the unit. 6. Place mug on the drip tray. 7. Press the 10 oz. cup button. Light will flash slowly and the hot water will start to dispense momentarily. 8. The one-time cleaning process is complete. Discard hot water. Your brewer is ready to use. USING THE SINGLESERVE COFFEEMAKER Follow instructions in Setting Up Your Single-Serve Coffeemaker above. BREWING 1. Remove water reservoir to fill. 3. Fill the reservoir in sink and put back on unit. 4. If you haven't already, plug the power cord into an independent outlet. Press the power switch on side of the unit to turn the unit on. 5. Open and close the brew head. Do not add a capsule. 2. Add water into the 40-ounce water reservoir. Replace on unit. 3. If not already turned on, press the power switch located on the side of your unit. Brew buttons will illuminate. 4. Place mug on the drip tray. The drip tray can be removed to accommodate travel mugs. 5. Select a capsule. NOTE: Do not remove the foil lid or puncture the capsule. 6. Open the brew head and place a capsule in the brewing chamber. Close brew head. Caution: There are two sharp needles in the brewing chamber that puncture the capsule, one above and one below. To avoid risk of injury, do not put your fingers in the capsule brewing chamber. 11