Cuisinart SS-15 Owner Manual - Page 8

CHARCOAL WATER FILTER INSERTING THE WATER FILTER 1. Remove the filter from the polybag and soak, fully immersed, in cold tap water for 15 minutes. 2. Lift the water filter holder out of the water reservoir the 12-Cup Coffeemaker side. 3. Press down on the filter compartment and pull toward you to open. 4. Place filter into the holder and snap closed. Be careful - improper placement can tear the filter skin. SETTING UP YOUR 12-CUP COFFEEMAKER INITIAL CLEANING Perform an initial cleaning before making your first beverage. Follow these instructions, without adding coffee. 1. Insert charcoal water filter if you haven't already. Instructions above. 2. Fill water reservoir. 5. Flush filter by running cold tap water through holes in bottom of compartment for 10 seconds. 6. Allow the filter to drain completely. 7. Slide the water filter holder back into the channel in the water reservoir, pushing down to the base of the unit. 3. Make sure carafe is in place. 4. If you haven't already, plug the power cord into an independent outlet. Power on unit by pressing the power switch on side of the unit. 5. Turn function knob to BREW. 6. Press the BREW button and allow brew cycle to run. 7. The one-time cleaning process is complete. Discard hot water. Your Coffeemaker is ready to use. PROGRAMMING YOUR 12-CUP COFFEEMAKER NOTE: Repeat steps 1-7 above on the Single-Serve side. NOTE: We recommend changing the water filter every 60 days or after 60 uses, and more often if you have hard water. Replacement filters can be purchased in stores, by calling Cuisinart Consumer Service, or at www.cuisinart.com SETTING THE CLOCK When the Coffeemaker is plugged in and power switch is turned on, 12:00 will flash. Turn the Function knob to CLOCK Press Hour and Minute buttons to select the desired time. Hold buttons down to scroll through the digits, or press and release to advance one digit at a time. When scrolling, the numbers will advance slowly and then speed up. When the number displayed approaches the desired time, press and release to advance one digit at a time. Be sure the PM indicator is on if a PM time is desired. To finish setting the clock, turn the Function knob to any other setting or simply wait until the numbers stop blinking. 8