CyberPower PR2200ELCDRTXL2U User Manual - Page 10
Lcd Setup Fuctions
View all CyberPower PR2200ELCDRTXL2U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
LCD SETUP FUCTIONS 1. General Mode: a. Press the "Display-Toggle" button to check the status of the UPS status: Item Unit 1 Input Voltage V 2 Output Voltage V 3 Output Frequency Hz 4 Load Kw 5 Estimate Run Time Min 6 Load Capacity % 7 Battery Capacity % 8 Centigrade ℃ 9 Fahrenheit ℉ b. Press and hold the "Display-Toggle" button for 4 seconds, If the machine is in the Battery Mode with active alarm, it will become silent. If the machine is in the Line Mode, a self- diagnostic test will take place. c. If the "Display-Toggle" button remains untouched for over 30 seconds, the LCD backlight will turn off automatically. 2. Set-up Mode Step 1: Hold the "Display-Toggle" button for 10 seconds to enter the UPS Set-Up Mode. Step 2: By pressing the Display toggle, users can switch between setup functions. Some User Configurable functions are as follows: a. Delay Time: The time delay between switching from Battery Mode to Line Mode. There are 9 different settings. The default setting is 0 minutes. b. Battery Pack Numbers: This function provides the estimated UPS runtime using various numbers of battery packs. The default setting is 0. c. Static Frequency Tolerance: There are 4 settings (1, 2, 4, 6 %), and the default setting is +/-6%. Functional description: The setting may be adjusted to the quality of the electricity in use. d. Slew rate: Also known as Dynamic Frequency Tolerance. There are 5 different settings (0.25, 0.5, 1, 2, 4 Hz/Sec). The fault value is 4Hz/sec. Functional Description: "Slew Rate" indicates the tolerance of a device in accepting frequency variance. Lower "Slew Rate" results in less tolerance but better protection for the connected load and vice versa. e. Low Battery Shutdown Voltage: This function will adjust the UPS shutdown point according to the battery's remaining capacity. These programmable items are sorted by unit as in the following table: Items Delay Time Battery Pack Numbers Voltage Mode (220/230/240) Static Frequency Tolerance Slew Rate Low Battery Shutdown Voltage Firmware Version Unit Min A V % Hz V None Step 3: Press and hold the display-toggle for 4 seconds. When the icons blink, the value of each item is changed by slightly pressing the toggle. 10 Copyright © 2016 CyberPower Systems, Inc.