D-Link DCS-4705E User Manual - Page 12
D-Link DCS-4705E User Manual, Step 6, If you are using PoE to power your camera
View all D-Link DCS-4705E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Section 2: Installation Step 5 Connect the RJ-45 plug into the Ethernet connector, then screw the waterproof connector to the Ethernet connector by turning it about a half-turn clockwise. Step 6 Screw the back part of the waterproof connector clockwise until there is a tight seal around the Ethernet cable. If you are using PoE to power your camera, use the power connector cap to seal the power connector. D-Link DCS-4705E User Manual 12
12
D-Link DCS-4705E User Manual
Section 2: Installation
Step 6
Screw the back part of the waterproof connector clockwise until there is a tight seal around
the Ethernet cable.
Step 5
Connect the RJ-45 plug into the Ethernet connector, then screw the waterproof connector to
the Ethernet connector by turning it about a half-turn clockwise.
If you are using PoE to power your camera,
use the power connector cap to seal the power
connector.