D-Link DES-3010PA-TAA CLI Guide - Page 351
dot1x single-host-violation
UPC - 790069296567
View all D-Link DES-3010PA-TAA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 351 highlights
802.1x Commands dot1x single-host-violation The dot1x single-host-violation Interface Configuration mode command configures the action to be taken, when a station whose MAC address is not the supplicant MAC address, attempts to access the interface. Use the no form of this command to return to default. Syntax dot1x single-host-violation {forward | discard | discard-shutdown} [trap seconds] no port dot1x single-host-violation Parameters • forward - Forwards frames with source addresses that are not the supplicant address, but does not learn the source addresses. • discard - Discards frames with source addresses that are not the supplicant address. • discard-shutdown - Discards frames with source addresses that are not the supplicant address. The port is also shut down. • trap - Indicates that SNMP traps are sent. • seconds - Specifies the minimum amount of time in seconds between consecutive traps. (Range: 1- 1000000) Default Configuration Frames with source addresses that are not the supplicant address are discarded. No traps are sent. Command Mode Interface Configuration (Ethernet) mode User Guidelines The command is relevant when multiple hosts is disabled and the user has been successfully authenticated. Examples The following example forwards frames with source addresses that are not the supplicant address and sends consecutive traps at intervals of 100 seconds. Console(config)# interface ethernet 6 Console(config-if)# dot1x single-host-violation forward trap 100 Page 350