D-Link DGS-1210-20 Reference Guide - Page 81
Command Line Interface, To connect a switch via TELNET:, Logging on to the Command Line Interface: - 52 default ip
View all D-Link DGS-1210-20 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 81 highlights
6 Command Line Interface D-Link Web Smart Switch User Manual 6 Command Line Interface The D-Link Web Smart Switch allows a computer or terminal to perform some basic monitoring and configuration tasks by using the Command Line Interface (CLI) via TELNET protocol. To connect a switch via TELNET: 1. Make sure the network connection between the switch and PC is active. 2. To connect, launch any terminal software like HyperTerminal in Microsoft Windows, or just use the command prompt by typing the command telnet followed by the switch IP address, eg. telnet 10.90.90.90. 3. The logon prompt will appear. Logging on to the Command Line Interface: Enter your User Name and Password to log in. The default user name and password is admin. Note that the user name and password are case-sensitive. Press Enter in both the Username and Password fields. The command prompt will appear as shown below (DGS-1210-52>): DGS-1210-52 login: admin Password: DGS-1210-52> Figure 6.1 - Command Prompt The user session is automatically terminated if idle for the login timeout period. The default login timeout period is 5 minutes. To change the login timeout session, please refer to chapter 5. CLI Commands: The Basic Switch commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following table. Command Parameter ? download upload config ipif system logout ping reboot reset config show ipif show switch config account admin password save debug info { firmware_fromTFTP tftp://ip-address/filename | cfg_fromTFTP tftp://ip-address/filename } { firmware_toTFTP tftp://ip-address/filename | cfg_toTFTP tftp://ipaddress/filename } { ipaddress gateway | dhcp | bootp } 76