D-Link DGS-3650 Product Manual - Page 291
BGP Network Settings, Parameter, Description, IP Address, Netmask, Summary Only, AS Set
UPC - 790069293603
View all D-Link DGS-3650 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 291 highlights
Parameter xStack® DGS-3600 Series Layer 3 Managed Gigabit Ethernet Switch Description IP Address Enter the IP network address to be aggregated. Netmask Enter the netmask of the IP network address to be aggregated. Summary Only Tick this check box to stop more specific routes from being advertised. The default setting is unticked. AS Set Tick this check box to generate Autonomous System set path information. The default setting is unticked. Click Apply to implement changes made. To remove an entry from the table, click its corresponding under the Delete heading. BGP Network Settings This window is used to specify the network advertised by the Border Gateway Protocol (BGP). To view this window, click L3 Features > BGP > BGP Network Settings, as shown below: Figure 4- 135. BGP Network Settings window To configure BGP network settings on the Switch, complete the following fields: Parameter Description IP Address Enter the IP address of the local network that BGP will advertise. Netmask Enter the netmask of the local network that BGP will advertise. Route Map Enter the route map to be applied to the advertised networks. If not specified, all networks are advertised. Click Apply to implement changes made. To remove an entry from the table, click its corresponding under the Delete heading. 275