D-Link DS-810 User Guide - Page 21

Rear Panel

Get D-Link DS-810 PDF manuals and user guides View all D-Link DS-810 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 21 highlights

10/100 Fast Ethernet Switch User's Guide The following section describes these indicators in detail. • Power LED This indicator is green when power is supplied to the device. The Power LED lights when you connect the power cable to the power receptacle at the rear of the device, and then plug it in to a power outlet. • Link/Act LED This indicator is green when the respective port is properly connected to a powered-on device and blinks green when packets are being transmitted or received. • 100M LEDs These indicators are green when port 1 or port 2 is connected to a device operating at 100Mbps. If either of these LEDs is off, then the port it corresponds to is either not connected or is connected to a device operating at 10Mbps. • FDX/Collision (Col) LED This indicator is green when the respective port is operating in fullduplex mode, and blinks yellow when collisions occur. Rear Panel The rear panel of the 10/100 Fast Ethernet Switch includes the power cable connector and the Duplex Mode Switch. Figure 3 Rear Panel Overview 11

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
10/100 Fast Ethernet Switch User’s Guide
Overview
11
The following section describes these indicators in detail.
•
Power LED
This indicator is green when power is supplied to the device. The Power
LED lights when you connect the power cable to the power receptacle at
the rear of the device, and then plug it in to a power outlet.
•
Link/Act LED
This indicator is green when the respective port is properly connected to
a powered-on device and blinks green when packets are being
transmitted or received.
•
100M LEDs
These indicators are green when port 1 or port 2 is connected to a device
operating at 100Mbps.
If either of these LEDs is off, then the port it
corresponds to is either not connected or is connected to a device
operating at 10Mbps.
•
FDX/Collision (Col) LED
This indicator is green when the respective port is operating in full-
duplex mode, and blinks yellow when collisions occur.
Rear Panel
The rear panel of the 10/100 Fast Ethernet Switch includes the power cable
connector and the Duplex Mode Switch.
Figure 3
Rear Panel