D-Link DSN-3200 Light Fix - Page 11
Step 12 Your DSN-3200/3400 is now ready to accept Seagate Barracuda ES.2 1TB SATA-II hard drives - 2008
 |
UPC - 790069299759
View all D-Link DSN-3200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
xStack Storage DSN-3200 & DSN-3400 ECN - Drive Activity Light Fix Figure 13: Another view of an installed resistor pack Step 9) Install a resistor pack on the remaining three 10-position headers. Step 10) Install the two (2) Molex power connectors labeled CN4 and CN7. These were removed earlier as shown in figure 8. Step 11) Replace the cover of the unit, reattach all cabling and power up the unit normally. Step 12) Your DSN-3200/3400 is now ready to accept Seagate Barracuda ES.2 1TB SATA-II hard drives (Seagate part number ST31000340NS). The drive activity lights will blink when drive activity is detected. D-Link Systems, Inc. February 7, 2008 Page 11
-
1 -
2
-
3
-
4
-
5
-
6 -
7 -
8 -
9 -
10 -
11
 |
 |
xStack Storage DSN-3200 & DSN-3400
ECN – Drive Activity Light Fix
D-Link Systems, Inc.
Page
11
February 7, 2008
Figure 13: Another view of an installed resistor pack
Step 9) Install a resistor pack on the remaining three 10-position headers.
Step 10) Install the two (2) Molex power connectors labeled CN4 and CN7.
These were removed earlier as
shown in figure 8.
Step 11) Replace the cover of the unit, reattach all cabling and power up the unit normally.
Step 12) Your DSN-3200/3400 is now ready to accept Seagate Barracuda ES.2 1TB SATA-II hard drives
(Seagate part number ST31000340NS).
The drive activity lights will blink when drive activity is detected.