DIRECTV RC32 User Manual - Page 11

11

component selected by the

MODE

switch. To enable this

feature, perform the following steps:

1.

Press and hold the

MUTE

and

SELECT

keys until the

green light under the

DIRECTV

position flashes twice,

then release both keys.

2.

Using the number keys, enter

9-9-3

.

(The green light

will flash twice after the

3

.)

3.

Press and release the

VOL

+

key. (The green light

flashes 4 times.)

Now the

VOL

and

MUTE

keys will work

only

for the

component selected by the

MODE

switch position.

To Lock Volume to AV1, AV2 or TV

1.

Slide the

MODE

switch to the

AV1

,

AV2

or

TV

position to

lock the volume.

2.

Press and hold the

MUTE

and

SELECT

keys until the

green light under the selected switch flashes twice and

release both keys.

3.


9-9-3

.

(The green light

flashes twice.)

4.

Press and release the

SELECT

key. (The green light

flashes twice.)

NOTE:

DIRECTV boxes don’t have volume control, so

the remote will not allow the user to lock volume

to the DIRECTV mode.

RESTORE FACTORY DEFAULT SETTINGS

To reset all the functions of the remote control to the

factory defaults (the original, out-of-the-box settings),

follow these steps:

1.

Press and hold the

MUTE

and

SELECT

keys at the same

time until the green light flashes twice, then release

both keys.

2.


9-8-1

.

(The green light

flashes 4 times.)

TROUBLESHOOTING

PROBLEM:

Light at the top of the remote blinks when you

press a key, but the component does not respond.

SOLUTION 1:

Try replacing the batteries (see page 6).

SOLUTION 2:

Make sure you are aiming the DIRECTV

®

Universal Remote Control at your home entertainment

component and that you are within 15 feet of the

component you are trying to control.

PROBLEM:

The DIRECTV Universal Remote Control does

not control component or commands are not recognized

properly.

SOLUTION:

Try all listed codes for the device brand being

set up. Make sure all components can be operated with an

infrared remote control.

PROBLEM:

TV/VCR combo does not respond properly.

Section	Page
DIRECTV®	1
Universal Remote Control	1
User Guide	1
contents	2
Introduction	3
Features and Functions	4
Key Charts	4
Installing Batteries	6
Controlling Your DIRECTV Receiver	7
Setting Up Your DIRECTV Remote	7
Onscreen Remote Setup	7
Controlling Your TV	7
Setting Up the TV Input Key	8
Deactivate the TV Input Select Key	8
Controlling Other Components	8
Searching for TV, AV1 or AV2 Codes	9
Verifying the Codes	10
Changing Volume Lock	10
To Lock Volume to AV1, AV2 or TV	11
Restore Factory Default Settings	11
Troubleshooting	11
DIRECTV Setup Codes	13
Setup Codes for DIRECTV Receivers	13
Setup Codes for DIRECTV HD Receivers	13
Setup Codes for DIRECTV DVRs	14
Setup Codes, Other Devices	14
Setup Codes for TVs	14
Setup Codes for VCRs	21
Setup Codes for DVD Players	26
Setup Codes for Audio Amplifiers/Tuners	29
Setup Codes for Audio Amplifiers	32
Repair or Replacement Policy	34
Additional Information	34
Compliance with FCC Rules and Regulations	35

DIRECTV RC32 User Manual - Page 11

To Lock Volume to AV1, AV2 or TV, Restore Factory Default Settings, Troubleshooting - universal remote control

Page 11 highlights