DIRECTV RC32 User Manual - Page 9
Searching for TV, AV1 or AV2 Codes, SELECT, NUMBER - remote codes
View all DIRECTV RC32 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
2. Locate the 5-digit code for your component. (See "Setup Codes, Other Devices" starting on page 14.) 3. Slide the MODE switch to the AV1 (or AV2) position. 4. Press and hold the MUTE and SELECT keys at the same time until the green light under AV1 (or AV2) flashes twice, then release both keys. 5. Using the NUMBER keys, enter the 5-digit code for the brand of component being set up. If performed correctly, the green light under the selected position flashes twice. 6. Aim the remote at your component and press the PWR key once. The component should turn off; if it does not, repeat steps 3 and 4, trying each code for your brand until you find the correct code. 7. Repeat steps 1 through 6 to set up a new component under AV2 (or AV1). 8. For future reference write down the working code for the component(s) set up under AV1 and AV2 below: AV1: COMPONENT AV2: COMPONENT SEARCHING FOR TV, AV1 OR AV2 CODES If you were unable to find the code for your brand of TV or component, you can try a code search. This process may take up to 30 minutes. 1. Turn on the TV or component. Insert a tape or disk if applicable. 2. Slide the MODE switch to the TV, AV1 or AV2 position, as desired. 3. Press and hold the MUTE and SELECT keys at the same time until the green light under the selected switch position flashes twice, then release both keys. 4. Enter 9-9-1 followed by one of the following fourdigits: 9