Dacor DCM24 Installation Instructions - Page 27

Cleaning And Care - stainless steel

Page 27 highlights

CLEANING AND CARE Disconnect the power cord before cleaning. If possible, leave the door open to inactivate the oven during cleaning. Exterior The outside surface is precoated metal and plastic. Clean the outside with mild soap and water; rinse and dry with a soft cloth. Do not use any type of household or abrasive cleaner. Door Wipe the window on both sides with a damp cloth to remove any spills or spatters. Metal parts will be easier to maintain if wiped frequently with a damp cloth. Avoid the use of harsh abrasives. Touch Control Panel Wipe the panel with a cloth dampened slightly with water only. Dry with a soft cloth. Do not scrub or use any sort of chemical cleaners. Close door and touch STOP/CLEAR. Interior - after microwave cooking. Cleaning is easy because no heat is generated to the interior surfaces; therefore, there is no baking and setting of spills or spattering. To clean the interior surfaces, wipe with a soft cloth and warm water. DO NOT USE ABRASIVE OR HARSH CLEANERS OR SCOURING PADS. For heavier soil, use mild soap; rinse thoroughly with hot water. Interior - after convection, mix or broil cooking. Spatters may occur because of moisture and grease. Wash immediately after use with hot, soapy water. Rinse and polish dry. Harder to remove spatters may occur if oven is not thoroughly cleaned or if there is long time/high temperature cooking. If so, you may wish to purchase an oven cleaner pad with liquid cleaner within it--not a soap filled steel pad-for use on stainless or porcelain surfaces. Follow manufacturer's directions carefully and be especially cautious not to get any of the liquid cleaner in the perforations on the wall or ceiling or any door surfaces. Rinse thoroughly and polish dry. After cleaning the interior thoroughly, residual grease may be removed from the interior ducts and heater by simply operating the oven on 450°F. for 20 minutes without food. Ventilate the room if necessary. Waveguide Cover Carefully wash any food particles from the waveguide cover located on the ceiling in the oven cavity. Odor Removal Occasionally, a cooking odor may remain in the oven. To remove, combine 1 cup water, grated peel and juice of 1 lemon, and several whole cloves in a 2 cup glass measuring cup. Boil for several minutes using 100% power. Allow to set in oven until cool. Wipe interior with a soft cloth. Turntable/Turntable Support/Racks The turntable, turntable support and racks can be removed for easy cleaning. Wash them in mild, sudsy water; for stubborn stains use a mild cleanser and a non-abrasive scouring sponge. They are also dishwasher-proof. Use top rack of dishwasher for turntable support. Foods with high acidity, such as tomatoes or lemons, will cause the porcelain enamel turntable to discolor. Do not cook highly acidic foods directly on the turntable; if spills occur, wipe up immediately. The turntable motor shaft is not sealed, so excess water or spills should not be allowed to stand in this area. 25

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32

25
Disconnect the power cord before cleaning. If possible, leave the door open to inactivate the oven during
cleaning.
Exterior
The outside surface is precoated metal and plastic. Clean the outside with mild soap and water; rinse and dry
with a soft cloth. Do not use any type of household or abrasive cleaner.
Door
Wipe the window on both sides with a damp cloth to remove any spills
or spatters. Metal parts will be easier to maintain if wiped frequently with
a damp cloth. Avoid the use of harsh abrasives.
Touch Control Panel
Wipe the panel with a cloth dampened slightly with water only. Dry with
a soft cloth. Do not scrub or use any sort of chemical cleaners. Close
door and touch STOP/CLEAR.
Interior
- after microwave cooking.
Cleaning is easy because no heat is generated to the interior surfaces;
therefore, there is no baking and setting of spills or spattering. To clean
the interior surfaces, wipe with a soft cloth and warm water. DO NOT
USE ABRASIVE OR HARSH CLEANERS OR SCOURING PADS. For
heavier soil, use mild soap; rinse thoroughly with hot water.
Interior
- after convection, mix or broil cooking.
Spatters may occur because of moisture and grease. Wash immediately
after use with hot, soapy water. Rinse and polish dry. Harder to remove
spatters may occur if oven is not thoroughly cleaned or if there is long
time/high temperature cooking. If so, you may wish to purchase an
oven cleaner pad with liquid cleaner within it--not a soap filled steel pad-
-for use on stainless or porcelain surfaces.
Follow manufacturer's directions carefully and be especially cautious
not to get any of the liquid cleaner in the perforations on the wall or
ceiling or any door surfaces.
Rinse thoroughly and polish dry.
After cleaning the interior thoroughly, residual grease may be removed
from the interior ducts and heater by simply operating the oven on
450°F. for 20 minutes without food. Ventilate the room if necessary.
Waveguide Cover
Carefully wash any food particles from the waveguide cover located on
the ceiling in the oven cavity.
Odor Removal
Occasionally, a cooking odor may remain in the oven. To remove,
combine 1 cup water, grated peel and juice of 1 lemon, and several
whole cloves in a 2 cup glass measuring cup. Boil for several minutes
using 100% power. Allow to set in oven until cool. Wipe interior with a
soft cloth.
Turntable/Turntable Support/Racks
The turntable, turntable support and racks can be removed for easy
cleaning. Wash them in mild, sudsy water; for stubborn stains use a
mild cleanser and a non-abrasive scouring sponge. They are also
dishwasher-proof. Use top rack of dishwasher for turntable support.
Foods with high acidity, such as tomatoes or lemons, will cause the
porcelain enamel turntable to discolor. Do not cook highly acidic foods
directly on the turntable; if spills occur, wipe up immediately.
The turntable motor shaft is not sealed, so excess water or spills should
not be allowed to stand in this area.
CLEANING AND CARE