Dacor DR30G Installation Instructions - Page 17

Installation Instructions Verifying Proper Operation WARNING Before operating the range, read the accompanying use and care manual completely. 1. Before beginning the test procedure, make sure all range control valves are in the "OFF" position, and all burner rings, burner caps and grates are properly positioned on the spill tray. OFF 2. Turn on the gas supply at the shut-off valve. 3. Connect the power cord to the electrical outlet. When the range is first connected, the oven indicator light flashes on and off for about 10 seconds while the range's circuitry starts up. Wait for the light to stop flashing before going to step 4. 4. Test the left front burner on the cooktop by pushing in and turning the control knob counterclockwise to the HIGH position. The igniter for the left front burner will HIGH spark continuously. It may take up to 4 seconds for the burner to ignite, at which time the ignitor will stop sparking. If ignition does not occur within 4 seconds, turn off the knob, wait for at least 5 minutes to allow any gas to dissipate, then repeat this ignition test. When the burner ignites, rotate the knob counterclockwise from HIGH to LOW to adjust the flame height progressively. When installed properly, the flame will be steady. It will also have a sharp, blue inner cone that will vary in length proportional to the burner size. LP gas units may have small yellow tips at the end of the flames, which is normal. 10. Turn the oven control knob to the BROIL position. The bake burner should turn off. Both the oven control knob and the oven ON indicator light should be illuminated. Within 60 seconds the broil burner on the ceiling of the oven should ignite and begin to give off heat. 11. Turn the oven knob to the OFF position. If the range does not operate properly, follow these troubleshooting steps: 1. Verify that the circuit breaker for the range electrical outlet is on and not tripped. Make sure the power cord is connected. 2. Make sure the gas supply valve is in the on position and that the main gas valve to the building is open. 3. Check to see if the oven burner light flashes on and off once a second. If it does, repair by an authorized service technician is required. 4. Repeat the above tests. 5. If the appliance still does not work, contact Dacor Distinctive Service at (800) 793-0093 ex. 2822. Do not attempt to repair the appliance yourself. Dacor is not responsible for the cost of correcting problems caused by a faulty installation. continued... Normal Flame 5. Repeat ignition test for the remaining cooktop burners. Make sure the knobs light when in the HIGH position. 6. After testing all the cooktop burners, turn them all off. 7. Open the oven door. Test the oven light by turning on the light switch on the right side of the control panel. 8. Turn on the convection fan switch. You should hear the convection fan, located behind the screen at the back of the oven, come on. 9. With the oven door open, turn the oven control knob to the 400 degree position. Both the knob itself and the oven ON indicator light next to the knob should illuminate. Within 60 seconds you should hear the bake burner ignite below the oven floor. It should begin to give off heat. 15