Dacor ER36D Installation Instructions - Page 18

Final Installation, Installing the Burner Knobs

Get Dacor ER36D PDF manuals and user guides View all Dacor ER36D manuals
Add to My Manuals
Save this manual to your list of manuals

Page 18 highlights

Installation Instructions Final Installation 1. Peel the protective coating off of the range, including the door. 2. Adjust the legs to the desired height. 3. Carefully slide the range into position in the cut-out. The rear anti-tip leg should engage the anti-tip bracket. Re-installing the Oven Door(s) WARNING To avoid personal injury or damage to the door from it falling off its hinges: • Make sure that the notch on the bottom of each hinge rests on top of the lower lip of each hinge receptacle before attempting to open the oven door. • Rotate the hinge locks toward the front of the range immediately after installation of the door. 1. Grasp the oven door on opposite sides and hold it at a 15° angle from the front of the oven. Slide the hinges into the hinge openings, resting the bottom of the hinge arms on the hinge receptacles. Continue to hold the door at a 15° angle with one hand while pushing in on each of the bottom corners of the door. Push until the notch on the bottom of each hinge slips over the lower lip of each hinge receptacle. 2. Lower the door to the fully opened position. 3. Rotate the two hinge locks toward the oven. 4. Slowly and carefully open and close the door completely to ensure that it is properly installed. 5. Remove any packaging from inside the oven(s). Installing the Burner Knobs caution Installing the range knobs in the wrong position may result in damage to the griddle included with the range. The knobs for the center burners are marked with the maximum griddle settings. NOTE: When installing the knobs, align the "D" shaped opening on the back of the knob with the end of the valve shaft. Carefully push the knob on until it stops. There are two (2) different types of knobs supplied with the range. The knobs for the center burners have the words "MAX GRIDDLE" on them. 1. Put the knobs with the words "MAX GRIDDLE" on them onto the inner (center burner) valve shafts. Icons on Center Burner Knobs 2. Put the remaining knobs on the outer valve shafts. Notch on bottom of hinge Lower lip of hinge receptacle Door Installation 16 Icons on Outer Burner Knobs

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
16
Installation Instructions
Final Installation
Peel the protective coating off of the range, including the
1.
door.
Adjust the legs to the desired height.
2.
Carefully slide the range into position in the cut-out. The rear
3.
anti-tip leg should engage the anti-tip bracket.
Re-installing the Oven Door(s)
WARNING
To avoid personal injury or damage to the door from it falling off
its hinges:
Make sure that the notch on the bottom of each hinge rests
•
on top of the lower lip of each hinge receptacle before
attempting to open the oven door.
Rotate the hinge locks toward the front of the range
•
immediately after installation of the door.
Grasp the oven door on opposite sides and hold it at a 15°
1.
angle from the front of the oven. Slide the hinges into the
hinge openings, resting the bottom of the hinge arms on the
hinge receptacles. Continue to hold the door at a 15° angle
with one hand while pushing in on each of the bottom corners
of the door. Push until the notch on the bottom of each hinge
slips over the lower lip of each hinge receptacle.
Lower the door to the fully opened position.
2.
Rotate the two hinge locks toward the oven.
3.
Slowly and carefully open and close the door completely to
4.
ensure that it is properly installed.
Remove any packaging from inside the oven(s).
5.
Installing the Burner Knobs
CAUTION
Installing the range knobs in the wrong position may result
in damage to the griddle included with the range. The knobs
for the center burners are marked with the maximum griddle
settings.
NOTE:
When installing the knobs, align the “D” shaped opening
on the back of the knob with the end of the valve shaft. Carefully
push the knob on until it stops.
There are two (2) different types of knobs supplied with the
range. The knobs for the center burners have the words “
MAX
GRIDDLE
” on them.
Put the knobs with the words “
1.
MAX GRIDDLE
” on them onto
the inner (center burner) valve shafts.
Put the remaining knobs on the outer valve shafts.
2.
Door Installation
Lower lip of
hinge receptacle
Notch on bottom
of hinge
Icons on Center Burner Knobs
Icons on Outer Burner Knobs