Dacor ER36D Use & Care Manuals - Page 10

Setting Up Your Range Cooktop Assembly warning To avoid the chance of fire, explosion or carbon monoxide poisoning, do not attempt to use your range without the burners completely and properly assembled. The burner rings spread the flame evenly around the burner cap. The burner rings must be properly seated for proper burner lighting and operation. Stack burners Crown Burner Assembly 1. Put the burner heads in place as shown below. The locating tab on the burner head goes in the keyed hole as shown. 2. Put the burner rings on the burner heads as shown below. Match the tabs on the bottom of the ring to the slots on the burner head. Twist each ring back and forth slightly to make sure it is properly seated. 3. Put the burner caps on top of the burner rings. The ridge around the bottom edge of the cap goes around the top of the burner ring. Step  Ridge on bottom of burner cap Step  Crown burners Tabs Slots Burner Locations Stack Burner Assembly 1. Put the burner rings on the burner bases as shown below. Match the correct sizes. The bottom of the correct size burner ring fits inside the top of the matching burner base. 2. Turn the ring until it drops into place. Twist each ring back and forth slightly to make sure it is properly seated. 3. Put the burner caps on top of the burner rings. The ridge around the bottom edge of the cap goes around the top of the burner ring. Ridge on bottom of burner cap Step  Put locating tab into keyed hole Keyed hole Step  Step  Burner ring Step  Burner base 8 Burner ring Burner head Burner base