Dacor ER36G Installation Instructions - Page 11
Door Removal, Install the Anti-Tip Bracket
![]() |
View all Dacor ER36G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Installation Instructions Install the Anti-Tip Bracket 1) Locate the anti-tip foot on the back of the range and turn it until the bottom of it is 1/16" (2 mm) off the floor. Back of range Door Removal Remove the door to make the range easier to move during the installation process. WARNING • Do not attempt to disengage the hinge catches with the door removed from the oven. The hinge springs could release causing personal injury. • The door is heavy. Door removal requires two people. Do not lift or carry the oven door by the door handle. 1) Open the door to its fully opened position. 2) Use a flat blade screwdriver to rotate the catch over the retaining arm on both hinges. Catch Anti-tip fFoot 2) Locate the anti-tip bracket included in the parts box. 3) Install the anti-tip bracket on the floor using the four (4) included screws. See the diagram below. Anti-Tip Bracket Placement A 5" (12.7 cm) B 2 3/4" (7.0 cm) Retaining arm 3) Lift the oven door to about a 15° angle from the vertical position. 4) Hold the door with both hands just below the handle. Pull the door up and away from the oven. A B Back of range Side of range Door Gripping Points 9
![](/manual_guide/products/dacor-er36g-installation-instructions-5b31cbd/11.png)