Dacor ETT365-2 Installation Instructions - Page 8

Installation Instructions Verify the Package Contents Verify that all the items below have been provided. If any item is missing or damaged, please contact your dealer immediately. Do not install a damaged or incomplete appliance. Make sure that you have everything necessary to ensure proper installation before proceeding. • Foam tape • Mounting brackets (2) • Glass scraper • Dacor Cooktop Cleaning Creme • Product literature Chassis Installation 4. Secure the cooktop to the countertop utilizing the two (2) hold-down brackets provided. Slide the brackets into the slots located on the left and right sides of the chassis, then tighten the screws to the underside of the countertop. Cooktop Foam tape seal Countertop Hold down bracket and screw warning If the electrical service provided does not meet the specifications on page 3, do not proceed with the installation. Call a licensed electrician to install the required wiring. IMPORTANT • Do not over-tighten the hold down bolts. Over tightening the hold down bolts may result in damage. • Do not use a hardening compound, glue or caulk to seal the cooktop into place. The cooktop must be readily removable if service is required. Removal of any sealant to service the unit will be performed at the customer's expense. 1. If the cooktop will be used with a raised vent, install the vent according to it's installation instructions first. Install it in the back of the cutout. 2. Attach the foam tape provided with the unit to the underside of the cooktop mounting surface. Electrical Connection warning • To prevent an electric shock or fire hazard, turn off power to the circuit at the circuit breaker or fuse box prior to connecting the cooktop wiring to the junction box. • Failure to connect the cooktop electrical wiring as specified may result in an electric shock hazard, a fire hazard and damage to the appliance. • Connect the ground (green) wire from the appliance to a grounded, metallic, permanent wiring system or grounding conductor. DO NOT ground the appliance with a neutral (white) house supply wire. A separate ground wire must be utilized. • This appliance must be properly grounded according to these instructions any time power is applied. • If aluminum house supply wiring is utilized, splice the appliance copper wires to the aluminum house wiring using special connectors designed and agency-certified for joining copper and aluminum. Follow the connector manufacturer's recommended procedure carefully. Improper connection may result in a fire hazard. Foam tape 3. Lower the cooktop into the cutout and center it. IMPORTANT Provide slack in the conduit to allow the cooktop to slide out for servicing. 1. Before proceeding, turn off power to the circuit to which the cooktop will be connected at the circuit breaker panel or fuse box. 2. Feed the appliance conduit into the electrical junction box and attach it using a UL certified strain relief. 3. Depending upon local codes, utilize one of the two methods shown on the facing page to connect the appliance to the power. 6