Dacor EWD24 Installation Instructions - Page 8

Installation Specifications Install Support Platform in Cabinet Provide a platform (100 lb. load capacity) within the cabinet upon which the warming drawer will be supported. The platform must be installed level and straight. The top edge of the platform must be flush with the cutout at the front of the cabinet. There are no provisions to level the warming drawer after it has been installed. 3/4" (1.9 cm) thick plywood is recommended. NOTE: If the drawer is not installed in a level fashion, the drawer may slide open on its own or may not seal tightly, allowing heat to escape and resulting in poor warming drawer performance. Chassis face Support platform Electrical and Environmental Specifications warning IMPORTANT: This appliance is equipped with a three prong grounding electric plug for protection against possible electric shock hazards. It must be plugged into a dedicated, grounded, electrical outlet. If only a two prong electrical outlet is available, it is the responsibility of the customer to have it replaced with a dedicated, properly grounded three prong electrical outlet. To avoid an electric shock hazard, do not under any circumstances: • Cut or remove the third (ground) prong from the power cord. • Use an adapter plug. • Use a power cord that is frayed or damaged. • Immerse the power cord or plug in water or other liquid. • Connect the appliance to an extension cord. NOTE: Use of a ground fault interrupter (GFI) is not recommended. Three prong plug Three prong grounded outlet • Minimum ambient operating temperature: 32°F (0°C). • The correct voltage, frequency and amperage must be supplied to the electrical outlet from a grounded, single phase circuit that is protected by a properly sized circuit breaker or time-delay fuse. • The required voltage, frequency and amperage ratings are listed on the product data label. See page 1 for location. Nominal Electrical Supply Requirements 120 Vac, 60 Hz, 15 Amp., dedicated circuit The warming drawer is supplied with a 40" (101.6 cm) power cord with a three prong grounded plug. Total Connected Load 0.5 kW (4 Amp.) • The power supply requirements shown above are for reference only. If they do not agree with those listed on the product data label, use the requirements on the product data label. • It is the owner's responsibility to ensure that the electrical outlet is installed by a qualified electrician. The electrical installation must comply with the latest revision of the National Electric Code ANSI/NFPA 70 and local codes and ordinances. • If the electrical service provided does not meet the product specification, or does not conform to the NEC or local standards, do not proceed with the installation. Call a licensed electrician to correct the electrical service before proceeding. • Be certain to locate the electrical outlet in an accessible location, so that the warming drawer may be easily unplugged in the event that service becomes necessary. • Keep the electrical cord away from hot surfaces. 6