Dacor MCS130S Use and Care Guide - Page 13

press CANCEL.SECURE

Page 13 highlights

7. Oven light will not work. 8. Door will not open. 9. Oven will not heat after Self Cleaning. Oven settings are not correct. Oven is set for Delay Timed Cleaning. Light bulb is burned out Oven is in Self-Clean mode. Time of day is not set due to power failure. Oven settings are not correct. Troubleshooting Guide (Continued) Follow mode selection and clock settings as specified in the SELF-CLEANING section. Oven will turn on automatically at preset time. If desired, press "CANCEL.SECURE" touch pad to cancel out Delay Timed Cleaning. Follow REPLACING THE OVEN LIGHT section If oven is hot, door latch wilI release automatically when oven temperature 390°F at end of cycle. falls betov If Self-Clean was just selected and the oven is still cool, press "CANCEL.SECURE" to turn off Self-Clean. The door will open in about 30 seconds. Press "CLOCK" touch pad, then press "TIME.TEMP" pad to set correct time of day. Follow mode selection and clock settings as specified in the OVEN OPERATION section. Oven will turn on automatically at preset time. If desired, press "CANCEL.SECURE" touch pad to cancel out of Delay Timed mode. Clock Display F0. F1. F2. F3. F4. F6. F7 F8. Cause Touch pad is stuck in depressed position. Relay circuit failure. Oven temperature exceeded the clean runaway temperature (Self-Clean mode only) or the cooking runaway temperature (cooking modes only). Short circuit in the oven temperature sensor. Open circuit in the oven temperature sensor. Failure in the EEPROM check comparison. (Only time of day and timer will operate.) Failure of the Self-Clean automatic door latch circuit. Failure of the door latch motor. Occurs when the motor runs for two minutes without the door locking in Self-Clean mode. Oven Failure Codes 11

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16

Oven settings
are not correct.
Follow mode selection
and clock
settings
as
specified
in the SELF-CLEANING
section.
Oven is set for Delay Timed
Cleaning.
Oven will turn on automatically
at preset time. If
desired,
press "CANCEL.SECURE"
touch
pad
to cancel out Delay Timed
Cleaning.
7. Oven
light will not work.
8. Door will not open.
Light bulb is burned
out
Oven is in Self-Clean
mode.
Follow
REPLACING
THE
OVEN
LIGHT
section
If oven is hot, door latch wilI release
automatically
when
oven temperature
falls betov
390°F
at end of cycle.
9. Oven
will not heat after Self Cleaning.
Time of day is not set due to power failure.
If Self-Clean
was just
selected
and the oven
is still cool,
press "CANCEL.SECURE"
to turn
off Self-Clean.
The door will open
in about 30
seconds.
Press "CLOCK"
touch
pad, then press
"TIME.TEMP"
pad to set correct
time of day.
Oven settings
are not correct.
Follow mode selection
and clock
settings
as
specified
in the OVEN
OPERATION
section.
Troubleshooting
Guide
(Continued)
Oven will turn on automatically
at preset time. If
desired,
press "CANCEL.SECURE"
touch
pad
to cancel out of Delay Timed
mode.
Clock
Display
Cause
F0.
Touch pad is stuck in depressed
position.
F1.
Relay circuit failure.
F2.
Oven
temperature
exceeded
the clean
runaway
temperature
(Self-Clean
mode
only) or the cooking
runaway
temperature
(cooking
modes only).
F3.
Short
circuit in the oven temperature
sensor.
F4.
Open circuit in the oven temperature
sensor.
F6.
Failure in the EEPROM
check comparison.
(Only time of day and timer will
operate.)
F7
Failure of the Self-Clean
automatic
door latch circuit.
F8.
Failure of the door latch motor. Occurs when
the motor
runs for two minutes
without
the door locking
in Self-Clean
mode.
Oven
Failure
Codes
11