Dacor MRES30S Installation Instructions - Page 6

WARNING: This appliance must be installed by a licensed plumber or gas fitter when installed within the Commonwealth of Massachusetts. Verifying the Package Contents If any item is missing or damaged, please contact your dealer immediately. Do not install a damaged or incomplete appliance. • Use and care manual • Anti-tip bracket • Broiler grill and pan • Oven racks • Razor blade scraper • Dacor Cooktop Cleaning Cream Installing the Anti-Tip Bracket WARNING: This appliance requires an antitip device. Before installing the range, you must locate and secure the anti-tip bracket to the floor. When the range is slid into position in the cutout, the left rear leveling leg slides into this bracket to prevent the unit from tipping forward. The bracket location shown here will position the rear edge of the range top frame flush to the rear wall. From this position, the bracket allows for up to 5/8" (16mm) of forward movement of the range. 1 1/2" (38mm) Front face of cabinet 19 7/16" (494mm) CL Removing the Oven Door WARNINGS: 1. Do not attempt to disengage the hinge catches with the door removed from the oven. The hinge springs could release causing personal injury. 2. Do not lift or carry the oven door by the door handle. Open the door to its fully opened position. Rotate the catch over the retaining arm on each hinge. Lift the oven door to about a 30 degree angle from the horizontal position. Pull the door away from the oven while continuing to lift. 30º 1) To remove door, rotate catch up 2) Lift door up to 30º angle, then pull door away from the oven Removing the Oven Door Remove the Kick Panel Remove the screw at each top corner of the kick panel. Lift up slightly on the panel and pull forward to remove. Electrical Connection NOTE: See the range data plate for electrical specifications. See page 1 for location. WARNINGS: 1. All of these range models must be connected to a grounded, metallic, permanent wiring system. Alternatively, a grounding conductor should be connected to the grounding terminal or lead on the appliance. 2. Do not use an extension cord with this appliance. Such use may result in fire, electrical shock, or other personal injury. 3. Do not install a fuse in the neutral or ground circuit. A fuse in the neutral or ground circuit may result in an electrical shock hazard. 4. Do not ground the appliance to a gas supply pipe or hot water pipe. 5. A grounded cold water pipe must have metal continuity to electrical ground and must not be interrupted by insulating materials. Any insulating materials must be jumped with a length of No. 4 copper wire securely clamped to bare metal at both ends. Connection Instructions: This appliance must be electrically grounded. With the range positioned directly in front of the cabinet cutout, feed the appliance conduit into the electrical junction box. Then, depending upon local codes, utilize one of the techniques on the facing page to connect the appliance to the electrical power supply. 2 3/16" (56mm) 11 3/8" (289mm) Top View - Location of Anti-Tip Bracket Based on 24" Cabinet Depth 5