Dacor RV36 Planning Guides - Page 3

Document # PG08-003 RV30, RV36, RV46 30", 36", 46" Wide, Raised Vent General System Layout (continued) ■■ The raised vent exhaust may be configured to vent through the bottom or through one of the sides. Allow room for the exhaust duct coming out of the unit. See Planning the Duct Work for additional details. ■■ The maximum allowable duct run must be taken into consideration when determining the layout. See Planning the Duct Work for further details. ■■ Access from the front of the cabinet to the underside of the cooktop, the vent system and the electrical and gas supplies for the cooktop and vent must be provided for inspection and service. Any drawers or shelves placed below the cooktop and in front of the vent must be easy to remove for access to the cooktop, vent and utilities. ■■ For installation with gas cooktops, a 90-degree elbow must be connected to the cooktop gas inlet (see diagram below) to avoid interference with the raised vent's front panel. 3 1/4" X 10" to 10" round transition and 45° adjustable elbow Cooktop Revised 03/29/10 Page 3/7 PLANNING GUIDE REMP16 Series Remote Blower Wall Board Backsplash Duct work between raised vent and remote blower 90° Elbow Raised Vent with internal cabinet blower mounted to front Raised vent configured for bottom exhaust Gas line with regulator attached Optional Internal Cabinet Blower Floor Wiring/conduit that supplies power to remote blower Example of Layout with Remote Blower, Roof Exhaust Cooktop Backsplash Wall Example of Gas Line Routing for Gas Cooktop Installations - Side View Internal cabinet blower Wall cap 3 1/4" x 10" 90˚ elbow floor Duct directly through rear wall to wall cap 12" (305 mm) Min. Example of Layout with Cabinet Blower, Exhaust Through Wall Specifications subject to change without notice. Install all appliances according to accompanying installation instructions. www.Dacor.com Phone: (800) 793-0093 8.9