Dacor SGM304 Planning Guides - Page 2

SGM304, SGM365, SGM466 Document # PG04-004 30", 36", 46" Wide, Gas Cooktops Revised 01/27/11 Page 2/5 PLANNING GUIDE Electrical Requirements WARNING To prevent an electric shock hazard, the power supply must meet the specifications stated below. It is the owner's responsibility to make sure that the electrical service meets electrical requirements and that the electrical outlet has been properly installed. ◊ The cooktop is supplied with a factory installed, 40-inch, three-prong, grounding electrical plug. It is connected to the chassis at the bottom right rear corner (see Chassis Bottom Diagram below). It must be connected to a dedicated, grounded three-prong electrical outlet installed by a licensed electrician. ◊ The electrical installation, including minimum supply wire size and grounding, must be done in accordance with National Electric Code ANSI/NFPA 70* and local codes and ordinances. A copy of this standard may be obtained from: National Fire Protection Association 1 Batterymarch Park Quincy, Massachusetts 02269-9101 ◊ The correct voltage, frequency and amperage must be supplied to the electrical outlet according to the product data label located on the bottom of the chassis. See the Gas and Electrical Requirements table on this page for reference. ◊ Be certain to locate the electrical outlet so that the power cord may be easily disconnected if the unit needs service. Front of unit Product data label Gas inlet Electric cord Chassis Bottom Diagram Gas Supply Requirements ◊ Be certain that the cooktop being installed is correct for the gas service being provided (natural gas or LP gas). Also, if operating the cooktop at an altitude above 4000 ft. (1219 m) make sure it is equipped for high altitude operation. ◊ Units equipped for LP operation have "LP" in the model number listed on the product data label. See the Chassis Bottom Diagram for label location. ◊ Units equipped for high altitude operation have an "H" at the end of the model number listed on the product data label. ◊ Check your local building codes for the proper method of installation. In the absence of local codes, this appliance should be installed in accordance with the National Fuel Gas Code ANSI Z223.1/NFPA 54. ◊ An external manual shut-off valve must be installed between the gas inlet and the cooktop for the purpose of turning on or shutting off gas to the appliance. ◊ The cooktop comes from the factory with a regulator in the shipping carton. Use only the regulator provided. The regulator must be installed in the gas line that runs from the cooktop gas inlet to the gas shut off valve. ◊ Models SGM304 and SGM365 come with a 1/2" regulator. Model SGM466 comes with a 3/4" regulator, approved for connection to a 1/2" house gas supply. The cooktop gas connection is located on the bottom of the cootktop in the back right corner as you face the front of the unit. See the Chassis Bottom Diagram on this page. SGM304 SGM365 SGM466 SGM304LP SGM365LP SGM466LP Gas type Natural LPG Manifold pressure 4" Water column 10" Water column Min. gas supply pressure** 5" Water column 11" Water column Max. gas supply pressure 1/2 p.s.i. 1/2 p.s.i. Total connected load 0.25 Amp. (0.03 kW) 0.25 Amp. (0.03 kW) Circuit requirement 120 Vac, 60 Hz, 15 Amp. 120 Vac, 60 Hz, 15 Amp. Gas and Electrical Requirements* * The electrical and gas data on this page is for reference only. If the above data does not agree with the product data label, use the data on the product data label. ** The gas supply pressure for testing the regulator setting shall be at least 1 inch water column (249 Pa) above the specified manifold pressure. Specifications subject to change without notice. www.Dacor.com Phone: (800) 7934-0.6093