Danby DPAC7008 User Manual - Page 13

Care and Maintenance CAUTION Before cleaning or servicing this unit, it is recommended that the unit be disconnected from any electrical supply outlet. 1) Do Not use gasoline, benzene, thinner or any other chemicals to clean this unit ,as these substances may cause damage to the finish and deformation of plastic parts. 2) Never attempt to clean the unit by pouring water directly over any of the surface areas, as this will cause deterioration of electrical components and wiring insulation. Storage and End of Season Care If the unit will not be in use for a long period oftime or is to be stored. 1. Remove the water tank and place a trip tray beneath sump drain tube Fig 7 (c). 2. Remove the black plug Fig 7 (d) to manually release the water from the internal reservoir. c Removal and Cleaning of the Air Filter If the air filter becomes clogged with dust/dirt, air flow is restricted and reduces cooling efficiency. The air filter should be cleaned every two (2) weeks. More frequent cleaning may be necessary depending upon indoor air quality. NOTE: The air filter is located at the (upper) rear side of the unit. 1) To remove the air filter: Pull the air filter cover upward in the direction of the arrow Fig 8 and remove the air filter. 2) Dust/Dirt clogged in the filter can be removed by vacuum cleaning the soiled areas. 4) The filter can also be washed in lukewarm soapy water while rubbing it lightly with a brush. A mild detergent (dishwashing soap) is recommended. 5) Rinse the filter well using clean water. Allow time to dry before reinstalling into the unit. 6) Replace the air filter and cover. 7) Replacement air filter information is available by the Customer Service Department at: 1-800-26-DANBY (1-800-263-2629) d Fig.7 CAUTION: Failure to replace and recap the direct sump drain tube prior to using the unit may resulting in flooding of the immediate area. CAUTION Never operate the unit without the air filter in place as this may result in damage to the unit. 12