Danby DWC276BLS Product Manual - Page 10

Installation Instructions - Door Swing Reversal 1. Unplug the unit from electrical oulet (if connected) and lay it on it's back. 2. Open the door until the screws securing the lower door support bracket are exposed on the bottom of the door (Fig 1B). 3. Remove the screw that is closest to the hinge assembly and gently close the door to remove the remaining screw from the support bracket. 4. Swing the door slightly towards the left side in order to remove the support bracket from the door and the lower hinge assembly. 5. Pull the door downward to remove it from the cabinet of the wine cooler. 6. Remove the cap from the top left side of the door (Fig 1D) and reinstall it on the top right side. 7. Remove the three (3) screws supporting the top hinge (Fig 1A). 8. Remove the plastic caps from the left side of the frame (Fig 1C) and reinstall them on the right side of the frame (the previous hinge location). 9. Install the new left hand hinge assembly (supplied with unit) on the left side of the frame. 10. Insert the lower door support into the left side bottom hinge. 11. Carefully reposition the door firstly into the left side upper hinge assembly then onto the lower door support bracket. 12. While the door remains closed install the first screw into the lower support bracket. 13. Open the door and install the screw that is closest to the hinge assembly. 14. Close the door and return the unit into it's upright position (wait 60 mins before reconnecting power to the wine cooler), verify the door alignment and proper seal against the cabinet. FIG 1D Door Plug FIG 1A Upper Hinge FIG 1C Plastic Caps (3) FIG 1B Lower Hinge Assembly and Door Support Bracket 9