Danby DWC276BLS Product Manual - Page 9

Installation Instructions - Intergrated Application Tools You Will Need FOR YOUR SAFETY: While performing installations described in this section, gloves, safety glasses or goggles should be worn. Safety Glasses Gloves Philips Screwdriver Level Flashlight Drill & Hole Saw set Measuring Tape Carpenter's Square Preparing the Enclosure Electrical Requirements: The appliance must be connected to an individual properly grounded electrical outlet, protected by a 15 or 20 ampere circuit breaker or time delay fuse. Important: It is recommended that you install the wine cooler in a location that allows the door(s) to have a greater then 45° opening swing. A limited door swing will prevent the shelves from sliding out as intended, and may lead to damaging the door gasket(s). • The rough cabinet opening must be on a level floor area and at least 24" deep* by 12-1/2" wide. The opening should also have a height of at least 34-1/2". • The electrical outlet may be positioned from within either side of the adjacent cabinetry, or the rear of the shaded area (as shown in Fig C.). Note: If the electrical outlet is surface mounted (not flush) within the enclosure, the depth requirment for the installation be affected. • If the electrical outlet is located inside the adjacent cabinetry, cut a 1-1/2" diameter hole to admit the power cord. Fig C 34-½" From Underside of Countertop to Floor 1-½" dia. hole *If electrical outlet is in adjacent * cabinetry 2" Electrical Access 6" 12-½" *The listed depth requirment for the installation is assuming that the electrical outlet is located in the adjacent cabinetry or is flush mounted in the rear wall, not surface mounted in the enclosure. 8