DeLonghi ECAM23450SL Owner Manual - Page 20

displayed messages EN DISPLAYED MESSAGE POSSIBLE CAUSE REMEDY FILL TANK ! • Insufficient water in the tank. • Fill the tank with water and/or insert it correctly, pushing it as far as it will go until it clicks into place (fig. 3B). EMPTY GROUNDS CONTAINER! • The grounds container (A14) is full. • Empty the grounds container and drip tray, clean and replace (fig. 22). Important: When removing the drip tray, the grounds container must be emptied, even if it is not completely full. If this is not done, when you make the next coffees, the grounds container may fill up more than expected and clog the machine. GROUND TOO FINE ADJUST MILL! alternating with... • The grinding is too fine and the coffee is • Repeat coffee delivery and turn the delivered too slowly or not at all. grinding adjustment knob (fig. 9) one click clockwise towards "7" while the coffee mill is in operation. If after insert water spout and press OK making at least 2 coffees delivery is still too slow, repeat the correction procedure, turning the grinding adjustment knob another click (see the section "Adjusting the coffee mill" on page 13). If the problem persists, press the button and deliver a little water from the spout. iNSERT GROUNDS CONTAINER! • After cleaning, the grounds container has not been replaced. • Remove the drip tray and insert the grounds container. ADD PRE-GROUND COFFEE! • The "pre-ground coffee" function has been selected without placing any preground coffee in the funnel. • Place pre-ground coffee in the funnel or deselect the "pre-ground" function. DESCALE! • The machine must be descaled. • The descaling procedure described in the "Descaling" section (page 17) needs to be performed as soon as possible. LESS COFFEE! • Too much coffee has been used. • Select a milder taste or reduce the quantity of pre-ground coffee. FILL BEANS CONTAINER! • The coffee beans have run out. • Fill the beans container • The pre-ground coffee funnel is clogged. • Empty the funnel with the help of a brush as described in the section "Cleaning the pre-ground coffee funnel". INSERT INFUSER ASSEMBLY! • The infuser has not been replaced after • Insert the infuser as described in the cleaning. section "Cleaning the infuser" (page 17). INSERT TANK • The tank is not correctly in place. • Insert the tank correctly and press as far as it will go. GENERAL ALARM! • The inside of the appliance is very dirty. • Clean the inside of the appliance thoroughly, as described in the section "Cleaning and maintenance" (page 16). If the message is still displayed after cleaning, contact a customer services. REPLACE FILTER • The water softener filter is exhausted. • Replace the filter or remove it as described in the section "Water softener filter" (page 19). 21