Definitive Technology UIW RCS II UIW RCSII Manual - Page 7

Gasket requirements and application, Connecting the speaker, Securing speaker - in ceiling speaker

Get Definitive Technology UIW RCS II PDF manuals and user guides View all Definitive Technology UIW RCS II manuals
Add to My Manuals
Save this manual to your list of manuals

Page 7 highlights

Gasket requirements and application • There are 2 sizes of gasket strips included in the accessory pack with the owner's manual. - 5 long gaskets. - 1 short gasket. • The gaskets are to be applied as follows: - 2 long gaskets on back of enclosure. - 2 gaskets on each side of enclosure to be placed against joist or framing material. - The short gasket is provided to run on the side of the enclosure where the terminal cut-away is located. Connecting the speaker • Run color-coded wires between the speaker cavity and amplifier unit. When running the wires inside the ceiling to the opening, leave a minimum of 18" of additional length in the cavity to facilitate speaker connection. • Fish wiring out of hole. • Connect the speaker wires to the UIW RCS II taking care to make red to red (+) and black to black (-) terminal connections. • Refer to your amplifier or receiver loudspeaker wiring instructions, turn off the unit and connect the speaker wires to the appropriate colored output terminal on the unit, again making red to red (+) and black to black (-) connections. This will ensure absolute phase throughout the system. Securing speaker • Installation of this product must follow all local and state building code requirements. • We strongly recommend using a qualified, professional installer who is knowledgeable of local building codes. • We recommend holding the unit by the bezel and outer edges of the speaker to avoid damaging the drivers. • Place speaker in hole and secure to joists (or framing material) with 4 screws provided. Tighten 2 screws on one side before installing and 7 tightening the opposing side.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
7
Gasket requirements and application
•
There are 2 sizes of gasket strips included in the accessory pack with the
owner’s manual.
–
5 long gaskets.
–
1 short gasket.
•
The gaskets are to be applied as follows:
–
2 long gaskets on back of enclosure.
–
2 gaskets on each side of enclosure to be placed against joist or
framing material.
–
The short gasket is provided to run on the side of the enclosure where
the terminal cut-away is located.
Connecting the speaker
•
Run color-coded wires between the speaker cavity and amplifier
unit. When running the wires inside the ceiling to the opening, leave a
minimum of 18" of additional length in the cavity to facilitate speaker
connection.
•
Fish wiring out of hole.
•
Connect the speaker wires to the UIW RCS II taking care to make red to
red (+) and black to black (-) terminal connections.
•
Refer to your amplifier or receiver loudspeaker wiring instructions, turn
off the unit and connect the speaker wires to the appropriate colored out-
put terminal on the unit, again making red to red (+) and black to black (-)
connections. This will ensure absolute phase throughout the system.
Securing speaker
•
Installation of this product must follow all local and state building
code requirements.
•
We strongly recommend using a qualified, professional installer who is
knowledgeable of local building codes.
•
We recommend holding the unit by the bezel and outer edges
of the speaker to avoid damaging the drivers.
•
Place speaker in hole and secure to joists (or framing material) with
4 screws provided. Tighten 2 screws on one side before installing and
tightening the opposing side.