Dell 1609WX User Guide - Page 41

Changing the Lamp - replacement lamp

Get Dell 1609WX - WXGA DLP Projector PDF manuals and user guides View all Dell 1609WX manuals
Add to My Manuals
Save this manual to your list of manuals

Page 41 highlights

Changing the Lamp The following message appears on the screen when your projector lamp is approaching end of life and requires to be changed: Lamp is approaching the end of its useful life in full power operation. Replacement suggested! www.dell.com/lamps CAUTION: Before you begin any of the procedures in this section, follow the Safety Instructions as described on page 6. To replace the lamp: 1 Turn off the projector and disconnect the Power cable. CAUTION: The lamp becomes very hot when in use. Do not attempt to replace the lamp until the projector has been allowed to cool down for at least 30 minutes. 2 Let the projector cool for at least 30 minutes. 3 Loosen the two screws that secure the lamp cover, and remove the cover. CAUTION: Do not touch the projector lamp or the lamp glass at any time. Projector lamps are very fragile and may shatter if touched. CAUTION: If the lamp shatters, remove all broken pieces from the projector and dispose or recycle according to state, local, or federal law. For more information see - www.dell.com/hg. 4 Loosen the two screws that secure the lamp. 5 Pull the lamp up by its metal handle. Troubleshooting Your Projector 41

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
Troubleshooting Your Projector
41
Changing the Lamp
The following message appears on the screen when your projector lamp is
approaching end of life and requires to be changed:
Lamp is approaching the end of its useful life in full power operation.
Replacement suggested! www.dell.com/lamps
CAUTION:
Before you begin any of the procedures in this section, follow the
Safety Instructions as described on page 6.
To replace the lamp:
1
Turn off the projector and disconnect the Power cable.
CAUTION:
The lamp becomes very hot when in use. Do not attempt to replace
the lamp until the projector has been allowed to cool down for at least 30
minutes.
2
Let the projector cool for at least 30 minutes.
3
Loosen the two screws that secure the lamp cover, and remove the cover.
CAUTION:
Do not touch the projector lamp or the lamp glass at any time.
Projector lamps are very fragile and may shatter if touched.
CAUTION:
If the lamp shatters, remove all broken pieces from the projector
and dispose or recycle according to state, local, or federal law. For more
information see - www.dell.com/hg.
4
Loosen the two screws that secure the lamp.
5
Pull the lamp up by its metal handle.