Dell 510D Service Manual
Dell 510D Manual
 |
View all Dell 510D manuals
Add to My Manuals
Save this manual to your list of manuals |
Dell 510D manual content summary:
- Dell 510D | Service Manual - Page 1
Dell™ Latitude™ D510 Service Manual Before You Begin System Components Memory Latch Fan System Board Flashing the BIOS Pin Assignments for Dell, the DELL logo, and Latitude are trademarks of Dell Inc.; Intel, Pentium, and Celeron are registered trademarks of Intel Corporation; Microsoft and Windows - Dell 510D | Service Manual - Page 2
Dell™ Latitude™ D510 Service Manual Small plastic scribe l Flash BIOS-update program floppy disk or Down. b. In the Shut Down window, click OK. The computer turns off press and hold the power button for 4 seconds follow the safety instructions in the Product Information Guide. CAUTION: Handle - Dell 510D | Service Manual - Page 3
your docking device for instructions. NOTICE: To disconnect a network cable, first unplug the cable from your computer and then unplug it from the network port or device. 4. Disconnect any telephone, network, and USB cables from the computer. 5. Disconnect your computer power supply and all attached - Dell 510D | Service Manual - Page 4
1 back 2 right 3 front 4 left Screw Identification When you are removing and replacing components, print this section as a guide to keep track of the screws. The placemat provides the number of screws and their sizes. Optical Device: (optional security screw) (1 each) Hard Drive: (2 each) - Dell 510D | Service Manual - Page 5
Display Panel: (8 each) Display Latch: (1 each) Palm Rest: (4 each) Display Assembly: (4 each) (14 each) Speakers: (1 each) Fan: (2 each) System Board: (2 each) (4 each) Back to Contents Page - Dell 510D | Service Manual - Page 6
to Contents Page Flashing the BIOS Dell™ Latitude™ D510 Service Manual NOTICE: To avoid damaging the system board, ensure you are connected to a known good electrical outlet and that you do not interrupt the BIOS flash process. Loss of power or an interruption during the BIOS flash process can cause - Dell 510D | Service Manual - Page 7
Dell™ Latitude™ D510 Service Manual CAUTION: Before performing the following procedures, read the safety instructions in your Product Information Guide hard drive. 1 internal card with Bluetooth wireless technology 2 system board connector 3 card connector 4 card cable To replace the internal card - Dell 510D | Service Manual - Page 8
1 cable 2 tab 3. Connect the card cable. 4. Replace the hard drive. Back to Contents Page - Dell 510D | Service Manual - Page 9
Back to Contents Page Coin Cell Battery Dell™ Latitude™ D510 Service Manual CAUTION: Before working inside your Dell™ computer, read the safety instructions in your Product Information Guide. NOTICE: To prevent damage to components inside your computer, discharge static electricity from your body - Dell 510D | Service Manual - Page 10
Page Microprocessor Module Dell™ Latitude™ D510 Service Manual Removing the Microprocessor Module Installing the Microprocessor Module Removing the Microprocessor Module CAUTION: Before performing the following procedures, read the safety instructions in your Product Information Guide. NOTICE: To - Dell 510D | Service Manual - Page 11
of the module are higher than the others, the module is not seated correctly. 2. Tighten the ZIF socket by turning the cam screw clockwise to secure the microprocessor module to the system board. 3. Replace the parts that you removed in Removing the Microprocessor Module. Back to Contents Page - Dell 510D | Service Manual - Page 12
Page Display Assembly and Display Latch Dell™ Latitude™ D510 Service Manual Display Assembly Display Bezel Display Panel Display Latch Display Assembly CAUTION: Before performing the following procedures, read the safety instructions in your Product Information Guide. NOTICE: To prevent damage to - Dell 510D | Service Manual - Page 13
1 display cable 2 display cable connector on system board 3 antenna cables (2) 4 antenna securing clips (2) 9. Remove the four M2.5 x 5- : Before performing the following procedures, read the safety instructions in your Product Information Guide. NOTICE: To prevent damage to components inside your - Dell 510D | Service Manual - Page 14
the front of the bezel. 1 display bumper 4 M2 x 5-mm screws (6) 2 support bracket 5 display bumpers (4) 3 display panel 6 display bezel NOTICE: Carefully separate the the following procedures, read the safety instructions in your Product Information Guide. NOTICE: To prevent damage to components - Dell 510D | Service Manual - Page 15
pull it away from the display connector. Display Latch CAUTION: Before performing the following procedures, read the safety instructions in your Product Information Guide. NOTICE: To prevent damage to components inside your computer, discharge static electricity from your body before you touch any - Dell 510D | Service Manual - Page 16
foil while removing the bracket. 6. Remove the M2 x 4-mm screw that secures the support bracket to the top cover. 7. Lift the support bracket out of the top cover, and then remove the display latch. NOTE: Ensure that the support bracket is upright when you replace the display latch. 1 top cover 2 M2 - Dell 510D | Service Manual - Page 17
Dell™ Latitude™ D510 Service Manual CAUTION: Before performing the following procedures, read the safety instructions in your Product Information Guide to disconnect it from the system board connector. 5. Free the fan cable from the cable routing pegs on the system board. 1 fan cable routing 2 fan - Dell 510D | Service Manual - Page 18
4 system board connector Back to Contents Page - Dell 510D | Service Manual - Page 19
Dell™ Latitude™ D510 Service Manual Before working inside your computer, read the safety instructions in your Product Information Guide. NOTICE: To prevent data loss, shut Dell does not guarantee compatibility or provide support for hard drives from sources other than Dell. 1. Follow the instructions - Dell 510D | Service Manual - Page 20
5. Install the operating system for your computer. 6. Install the drivers and utilities for your computer. Removing the Hard Drive From Its CAUTION: Before working inside your computer, read the safety instructions in your Product Information Guide. NOTICE: Hard drives are extremely fragile; even a - Dell 510D | Service Manual - Page 21
Back to Contents Page Keyboard Dell™ Latitude™ D510 Service Manual CAUTION: Before performing the following procedures, read the safety instructions in your Product Information Guide. NOTICE: To prevent damage to components inside your computer, discharge static electricity from your body before you - Dell 510D | Service Manual - Page 22
computer, to allow access to the keyboard connector. c. Pull the keyboard connector tab to disconnect the keyboard connector from the system board. d. Set the keyboard aside. 1 M2.5 x 5-mm screws (2) 2 keyboard connector tab 3 keyboard connector NOTE: When you replace the keyboard, ensure that the - Dell 510D | Service Manual - Page 23
Back to Contents Page Base Latch Dell™ Latitude™ D510 Service Manual CAUTION: Before performing the following procedures, read the safety instructions in your Product Information Guide. NOTICE: To prevent damage to components inside your computer, discharge static electricity from your body before - Dell 510D | Service Manual - Page 24
Back to Contents Page Palm Rest Dell™ Latitude™ D510 Service Manual CAUTION: Before performing the following procedures, read the safety instructions in your Product Information Guide. NOTICE: To prevent damage to components inside your computer, discharge static electricity from your body before - Dell 510D | Service Manual - Page 25
M2.5 x 5-mm screws labeled "P" (4) 7. Use the touch pad connector tab to disconnect the touch pad connector from the system board. 1 touch pad connector 2 system board connector NOTICE: Carefully separate the palm rest from the computer base to avoid damage to the palm rest. 8. Starting at the back - Dell 510D | Service Manual - Page 26
Back to Contents Page Pin Assignments for I/O Connectors Dell™ Latitude™ D510 Service Manual USB Connector Video Connector Parallel Connector S-Video TV-Out Connector Serial Connector IEEE 1394 Connector USB Connector Pin Signal 1 USB5V+ 2 USBP- 3 USBP+ 4 GND Video Connector - Dell 510D | Service Manual - Page 27
1 STROBE- 10 ACK- 2 PD0 11 BUSY 3 PD1 12 PE 4 PD2 13 SLCT 5 PD3 14 AFD/3M- 6 PD4 15 ERROR- 7 PD5 16 INIT- 8 PD6 17 SLIN- 9 PD7 18-25 GND S-Video TV-Out Connector S-Video Pin Signal 1 GND 2 GND 3 DLUMA-L 4 DCRMA-L Composite Video Pin Signal 5 NC 6 DCMPS-L 7 GND Serial - Dell 510D | Service Manual - Page 28
Pin Signal 1 TPB- 2 TPB+ 3 TPA- 4 TPA+ Back to Contents Page - Dell 510D | Service Manual - Page 29
Dell™ Latitude™ D510 Service Manual CAUTION: Before performing the following procedures, read the safety instructions in your Product Information Guide the clip closed. 5. Disconnect the speaker connector from the system board connector. NOTICE: Handle the speakers with care to avoid damaging them - Dell 510D | Service Manual - Page 30
System Board Dell™ Latitude™ D510 Service Manual Removing the System Board Installing the System Board Removing the System Board CAUTION: Before performing the following procedures, read the safety instructions in your Product Information Guide. The system board's BIOS chip contains the Service Tag - Dell 510D | Service Manual - Page 31
the computer. NOTE: After replacing the system board, enter the computer Service Tag into the BIOS of the replacement system board. 3. Insert the floppy disk or CD that accompanied the replacement system board into the appropriate drive and follow the instructions that appear on the screen. Back to - Dell 510D | Service Manual - Page 32
Components Dell™ Latitude™ D510 Service Manual NOTICE: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell is assembly 12 hard drive 6 graphics cooling assembly 13 speakers 7 system board 14 fan Back to Contents Page - Dell 510D | Service Manual - Page 33
-Cooling Assembly Dell™ Latitude™ D510 Service Manual Removing the Microprocessor Thermal-Cooling Assembly Installing the Microprocessor Thermal-Cooling Assembly Removing the Microprocessor Thermal-Cooling Assembly CAUTION: Before performing the following procedures, read the safety instructions in - Dell 510D | Service Manual - Page 34
9. Lift the microprocessor thermal-cooling assembly up and to the right to remove it from the system board. Installing the Microprocessor Thermal-Cooling Assembly NOTICE: Ensure that you do not trap any cables beneath the microprocessor thermal-cooling assembly when you replace it. 1. - Dell 510D | Service Manual - Page 35
the tab on the palm rest and place it between its routing clips. 4. Attach the display cable to the display panel connector on the system board. 5. Reconnect the two antenna cables and then secure them into the two antenna-securing clips. Back to Contents Page - Dell 510D | Service Manual - Page 36
Contents Page Dell™ Latitude™ D510 Service Manual Notes, Notices, and Cautions NOTE: A NOTE indicates important information that helps you make better use of your computer. NOTICE: A NOTICE indicates either potential damage to hardware or loss of data and tells you how to avoid the problem. CAUTION - Dell 510D | Service Manual - Page 37
, Mini PCI Card, and Optical Devices Dell™ Latitude™ D510 Service Manual Memory Module Modem Mini PCI Card Optical Devices Memory Module CAUTION: Before working inside your Dell™ computer, read the safety instructions in your Product Information Guide. NOTICE: To prevent damage to components inside - Dell 510D | Service Manual - Page 38
added, as the computer boots it detects the additional memory and automatically updates the system configuration information. Modem CAUTION: Before performing the following procedures, read the safety instructions in your Product Information Guide. NOTICE: To prevent damage to components inside your - Dell 510D | Service Manual - Page 39
with the modem connector on the system board and then press down on the captive screw. NOTICE: If the memory module cover is difficult to close, Dell has already installed the card for you. CAUTION: Before working inside your computer, read the safety instructions in your Product Information Guide - Dell 510D | Service Manual - Page 40
device security screw in the bay, if desired, to make the device more difficult to remove. CAUTION: Before working inside your computer, read the safety instructions in your Product Information Guide. NOTICE: Insert devices into the module bay before you dock and turn on the computer. - Dell 510D | Service Manual - Page 41
the computer. 2. If the computer is connected to a docking device (docked), undock it. See the documentation that came with your docking device for instructions. NOTICE: To prevent damage to devices, place them in a safe, dry place when they are not installed in the computer. Avoid pressing down on - Dell 510D | Service Manual - Page 42
1 M2 x 3-mm screw 5. Press the device latch release so that the latch release pops out. 6. Pull the device by the latch release to remove the device from the module bay. 7. Push the new device into the bay until it clicks. Back to Contents Page
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
-
17
-
18
-
19
-
20
-
21
-
22
-
23
-
24
-
25
-
26
-
27
-
28
-
29
-
30
-
31
-
32
-
33
-
34
-
35
-
36
-
37
-
38
-
39
-
40
-
41
-
42
 |
 |
Dell™ Latitude™ D510 Service Manual
Notes, Notices, and Cautions
Information in this document is subject to change without notice.
© 2005 Dell Inc. All rights reserved.
Reproduction in any manner whatsoever without the written permission of Dell Inc.
is strictly forbidden.
Trademarks used in this text:
Dell
, the
DELL
logo, and
Latitude
are trademarks of Dell Inc.;
Intel, Pentium, and Celeron are
registered trademarks of Intel Corporation;
Microsoft
and
Windows
are registered trademarks of Microsoft Corporation;
Bluetooth
is a trademark owned by Bluetooth SIG, Inc. and is used by Dell Inc. under license.
Other trademarks and trade names may be used in this document to refer to either the entities claiming the marks and names or their products. Dell Inc. disclaims any
proprietary interest in trademarks and trade names other than its own.
Model PP10L
April 2005 Rev. A00
Before You Begin
System Components
Memory Module, Modem, Mini PCI Card, and Optical Devices
Hard Drive
Internal Card With Bluetooth
®
Wireless Technology
Keyboard
Coin Cell Battery
Microprocessor Thermal
-
Cooling Assembly
Microprocessor Module
Display Assembly and Display Latch
Palm Rest
Speakers
Base Latch
Fan
System Board
Flashing the BIOS
Pin Assignments for I/O Connectors
NOTE:
A NOTE indicates important information that helps you make better use of your computer.
NOTICE:
A NOTICE indicates either potential damage to hardware or loss of data and tells you how to avoid the problem.
CAUTION:
A CAUTION indicates a potential for property damage, personal injury, or death.