Dell Dimension 3100C Service Manual - Page 28

Media Card Reader

Get Dell Dimension 3100C PDF manuals and user guides View all Dell Dimension 3100C manuals
Add to My Manuals
Save this manual to your list of manuals

Page 28 highlights

5. Attach the power and data cables to the floppy drive. 6. Connect the other end of the data cable to the connector labeled "FLOPPY" on the system board and route the cable through the clip on the shroud. 1 FlexBay 2 power cable 3 data cable 7. Check all cable connections, and fold cables out of the way to provide airflow for the fan and cooling vents. 8. Replace the drive panel. 9. Replace the computer cover. NOTICE: To connect a network cable, first plug the cable into the network device and then plug the cable into the computer. 10. Connect your computer and devices to their electrical outlets, and turn them on. See the documentation that came with the drive for instructions on installing any software required for drive operation. 11. Enter system setup and select the appropriate Diskette Drive option. 12. Verify that your computer works correctly by running the Dell Diagnostics. Media Card Reader Removing a Media Card Reader CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide. NOTICE: To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your computer's electronic components. You can do so by touching an unpainted metal surface on the computer chassis. 1. Follow the procedures in "Before You Begin." 2. Remove the drive panel.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
5.
Attach the power and data cables to the floppy drive.
6.
Connect the other end of the data cable to the connector labeled "FLOPPY" on the
system board
and route the cable through the clip on the shroud.
7.
Check all cable connections, and fold cables out of the way to provide airflow for the fan and cooling vents.
8.
Replace the
drive panel
.
9.
Replace the
computer cover
.
10.
Connect your computer and devices to their electrical outlets, and turn them on.
See the documentation that came with the drive for instructions on installing any software required for drive operation.
11.
Enter
system setup
and select the appropriate
Diskette Drive
option.
12.
Verify that your computer works correctly by running the
Dell Diagnostics
.
Media Card Reader
Removing a Media Card Reader
1.
Follow the procedures in "
Before You Begin
."
2.
Remove the
drive panel
.
1
FlexBay
2
power cable
3
data cable
NOTICE:
To connect a network cable, first plug the cable into the network device and then plug the cable into the computer.
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.
NOTICE:
To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your
computer's electronic components. You can do so by touching an unpainted metal surface on the computer chassis.