Dell Force10 E600i Quick Start Guide - Page 43
Con the Management Port IP Address, Con a Management Route
View all Dell Force10 E600i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
Configure the Management Port IP Address Assign IP addresses to the management ports in order to access the system remotely. NOTE: Assign different IP addresses to each RPM's management port. Step Task Command Syntax Command Mode 1 Enter INTERFACE mode for the interface CONFIGURATION Management port. ManagementEthernet slot/port 2 Assign an IPv4 or IPv6 address ip address {ipv4- to the interface. address | ipv6- address}/mask INTERFACE 3 Enable the interface. no shutdown INTERFACE Configure a Management Route Define a path from the system to the network from which you are accessing the system remotely. Management routes are separate from IP routes and are only used to manage the system through the management port. Task Command Syntax Command Mode Configure an IPv4 or IPv6 management route to the network from which you are accessing the system. management route {ipv4-address | ipv6- CONFIGURATION address}/mask gateway Configure a Username and Password Configure a system username and password to access the system remotely. Installing the Software 41