Dell Force10 S25N-S50N Dell Force10 S25 Systems Quick Start Guide - Page 7

1 Installing the Hardware This guide assumes all site preparation has been performed before installing the chassis. Installing the Chassis in a Rack or Cabinet To install the S25N, S25V, or S25P system, Dell Force10 recommends that you complete the installation procedures in the order presented below. NOTE: Unless stated otherwise, the installation instructions below apply to the S25N, S25V, and S25P systems. Always handle the system and its components with care. Avoid dropping the switch or its field replaceable units. CAUTION: Always wear an ESD-preventive wrist or heel ground strap when handling the chassis and its components. As with all electrical devices of this type, take all necessary safety precautions to prevent injury when installing this system. Electrostatic discharge (ESD) damage can occur if components are mishandled. Installing a Chassis in a Two-Post Rack The chassis is shipped with the universal front-mounting brackets (rack ears) attached. Ensure that there is adequate clearance surrounding the rack to permit access and airflow. The S25 chassis can be installed using several methods. This document describes the most common installation method: two-post rack. For information regarding other installation methods, refer to the Installing S25N and S25V Systems guide and the Installing the S25P System guide. This document does not include stacking or installing stacked units. Refer to the Installing S25N and S25V Systems guide and the Installing the S25P System guide for details on stacking installation and cabling. Installing the Hardware 5