Dell Force10 S25N-S50N Dell Force10 S50N and S50V Systems Quick Start Guide - Page 16

Step Task 1 Install the RJ-45 copper cable that is shipped with the S50V system into the console port. CAUTION: You must install a straight-through RJ-45 copper cable (a standard Ethernet cable) into the console port. This is different from many other implementations that require an Ethernet crossover cable (or rollover cable). If connecting to a terminal server and using a crossover cable, daisychain another crossover cable to effectively get a straightthrough cable connection. Many console terminal servers use octopus cables that are crossover cables. To accommodate the octopus cable, connect an additional crossover cable, as above, to effectively install a straight-through cable. 2 If necessary, connect the RJ-45/DB-9 adapter that is shipped with the S50V system to the end of the RJ-45 cable that will connect to your terminal. 3 Set your initial console terminal settings to match the default console settings on the switch. 9600 baud rate No parity 8 data bits 1 stop bit No flow control (console port only) After establishing a connection, you can modify the settings to match at each end of the connection. Accessing the Console Port Connect the RJ-45/DB-9 adapter that is shipped with the S50V system to the RJ45 cable. Table 2-1. Pin Assignments for Console Port Signal NC NC RXD RJ-45 Pinout 1 2 3 14 Installing the Software