Dell Force10 S25N-S50N Dell Force10 S50N and S50V Systems Quick Start Guide - Page 20
Assign Interfaces to a VLAN, interfaces, switchport
View all Dell Force10 S25N-S50N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
Assign Interfaces to a VLAN A port may either be an untagged member of a single VLAN, or a tagged member of perhaps multiple VLANs. • Untagged Ports - ports that do not append an 802.1Q VLAN tag to frames on egress, and do not accept tagged frames on ingress (tagged frames are dropped). Untagged ports must be connected to VLAN-unaware devices. • Tagged Ports - ports that append an 802.1Q tag to frames on egress, and accept only tagged frames on ingress (untagged frames are dropped). Tagged ports must be connected to VLAN-aware devices. When you configure an enabled port as a switchport, the port is placed in the default VLAN. To remove a switchport from the default VLAN, remove the switchport configuration. To move the port to another VLAN, add it to the desired VLAN as either a tagged or untagged member. To view just the interfaces that are in Layer 2 mode, enter the show interfaces switchport command in the EXEC mode. Step Task Command Syntax 1 Assign a switchport to [tagged | untagged] interface a VLAN. 2 Display all show vlan switchports and the VLANs of which they are members. Command Mode INTERFACE VLAN EXEC Privilege Assign an IP address to a VLAN NOTE: An IP address cannot be assigned to the Default VLAN, which, by default, is VLAN 1. To assign another VLAN ID to the Default VLAN, use the default vlan-id vlan-id command. Task Command Syntax Configure an IP address and mask on ip address ip-address the interface. mask [secondary] Command Mode INTERFACE 18 Installing the Software