Dell Force10 S50-01-GE-48T FTOS 8.4.2.7 Configuration Guide for E-Series TeraS - Page 1162

www.dell.com | support.dell.com Create an egress ACL and apply rules to the ACL To create an egress ACL and apply rules to the ACL in one single XML request, first enter FTOS XML mode, and then construct the configuration request (see Run an FTOS XML session on page 1159). The following example shows a configuration request message that accomplishes this task: interface GigabitEthernet 0/0 ip access-group abcd out ip access-list extended abcd seq 5 permit tcp any any seq 10 deny icmp any any permit 1.1.1.2 XML Error Conditions and Reporting This section contains examples of various error conditions that might occur in an XML transaction, and the associated responses that the XML generates. Note also, as shown below by the "NO_ERROR" message, that the same response message format is used for a successful configuration request. The general form of the response is as follows: Summary of XML Limitations • The XML response to a show running-configuration request is encoded in one single XML tag, instead of the standard XML-encoded response. • A show command, in an XML request, requires for the operation tag; the request is not supported if is used for the operation tag. • Only allowed one show command is supported within a single XML request. • XML namespace is not supported. Error Messages The following strings can appear after the tag: • XML_PARSE_ERROR • CLI_PARSE_ERROR-This error is caused by: - Malformed XML or mismatched XML tags 1162 | FTOS XML Feature