Dell Force10 S50-01-GE-48T FTOS 8.4.2.7 Configuration Guide for E-Series TeraS - Page 1188

www.dell.com | support.dell.com Figure 60-17. Viewing Offline Diagnostics Test Results (continued) Test 107 - NVRAM Address Line test PASS Test 108 - NVRAM Data Line Test PASS Test 110 - NVRAM Read Write test PASS .Test 111 - FLASH Write Read test PASS Test 112 - FPGA Registers Verification Test PASS Test 113 - FPGA Level1 Test PASS Test 114 - FPGA Data bus walking 0 and 1's test PASS Test 115 - Temp/volt monitor write read test PASS Test 116 - Reg verification test POE manager 1 NOT APPL Test 117 - Reg verification test POE manager 2 NOT APPL Test 118 - Reg verification test POE manager 3 NOT APPL Test 119 - Reg verification test POE manager 4 NOT APPL Test 120 - EEPROM write read test PASS Test 122 - Blinking Status LEDs Test PASS Test 123 - PHY MGT DEV 0 Level1 Test PASS Test 124 - PHY IPC DEV 2 level1 Test PASS Test 125 - PHY IPC DEV 3 level1 Test PASS Test 126 - Local Eeprom MFG block checksum test PASS Test 127 - Local Eeprom SW block checksum test PASS Test 128 - 3.3 V Brick Load test PASS Test 129 - 2.5 V Brick Load test PASS Test 130 - 1.5 V Brick Load test PASS Test 131 - 1.25 V Brick Load test PASS Test 132 - 1.8 V Brick Load test PASS Test 133 - XFP Verification Test 0 PASS Test 134 - XFP Verification Test 1 PASS Test 135 - XFP Verification Test 2 PASS Test 136 - XFP Verification Test 3 PASS Test 137 - XFP Verification Test 4 NOT APPL Test 138 - XFP Verification Test 5 NOT APPL Test 139 - XFP Verification Test 6 NOT APPL Test 140 - XFP Verification Test 7 NOT APPL LEVEL 2 DIAGNOSTICS Test 200 - MAC MGT DEV 0 Level2 Test PASS Test 201 - MAC IPC DEV 0 Level2 Test PASS Test 202 - MAC IPC DEV 1 Level2 Test PASS Test 203 - PHY MGT DEV 0 Level2 Test PASS Test 204 - PHY IPC DEV 0 Level2 Test PASS Test 205 - PHY IPC DEV 1 Level2 Test PASS Test 216 - F10-SFM Port wise Traffic Test with PHY Loopback ......... PASS Test 218 - LCM SNAKE Test using CPU Traffic with MAC Loopback ....... PASS Test 219 - LCM SNAKE Test using CPU Traffic with PHY Loopback ....... PASS Test 220 - LCM Port wise Traffic Test using CPU traffic - MAC Loopbac PASS Test 221 - LCM Port wise Traffic Test using CPU traffic - PHY Loopbac PASS Test 222 - POE I2C Interface stress test on Unit - 0 NOT APPL Test 223 - POE I2C Interface stress test on Unit - 1 NOT APPL Test 224 - POE I2C Interface stress test on Unit - 2 NOT APPL Test 225 - POE I2C Interface stress test on Unit - 3 NOT APPL *********** FORCE10 C series Diagnostics END Number of Diagnostics performed 69 Number of Diagnostics failed 0 End of Diags Duration of execution: 3 min 18 sec Bring the line card online Bring the card back online using the online linecard command. The card will be reset. Use the show linecard all command to verify the online status of the line card. 1188 | C-Series Debugging and Diagnostics