Dell Inspiron 24 5421 All-in-One Owners Manual - Page 61
Removing and installing Customer Replaceable Units CRUs, About this task, Steps
View all Dell Inspiron 24 5421 All-in-One manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 61 highlights
About this task NOTE: The M.2 card installed on your computer will depend on the configuration ordered. The supported card configurations on the M.2 card slot are: ● M.2 2230 solid-state drive ● M.2 2280 solid-state drive NOTE: This procedure applies if you are installing an M.2 2280 solid-state drive. If you are replacing an M.2 2230 solid-state drive with an M.2 2280 solid-state drive, move the screw mount as shown in the following figure, before you perform the other steps in the installation procedure. The following image indicates the location of the solid-state drive and provides a visual representation of the installation procedure. Steps 1. Ensure that the thermal pad covering the M.2 2280 slot on the system board is in place. 2. Align the notch on the solid-state drive with the tab on the M.2 card slot. 3. Slide the solid-state drive into the M.2 card slot on the system board. 4. Replace the screw (M2x3.5) that secures the solid-state drive to the system board. Removing and installing Customer Replaceable Units (CRUs) 61