Dell Inspiron Zino HD 410 Service Manual - Page 21

Back to Contents Page Infrared Board Dell™ Inspiron™ 410 Service Manual Removing the Infrared Board Replacing the Infrared Board WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance. CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™ is not covered by your warranty. CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such as a connector on your computer). Removing the Infrared Board 1. Follow the procedures in Before You Begin. 2. Remove the top cover (see Removing the Top Cover). 3. Remove the top bracket (see Removing the Top Bracket). 4. Remove the optical drive (see Removing the Optical Drive). 5. Remove the drive bay (see Removing the Drive Bay). 6. Disconnect the infrared cable from the infrared connector on the system board. 7. Lift the release latch and remove the infrared board from the slot on the chassis. 1 infrared cable connector 3 infrared board 2 release latch Replacing the Infrared Board 1. Follow the procedures in Before You Begin. 2. Replace the infrared board in the slot, and press it in, until it clicks into place. 3. Connect the infrared cable to the infrared connector on the system board (see System Board Components).