Dell Latitude 12 Rugged Extreme Dell 7204Series Owners Manual - Page 25

Installing the Global Positioning System (GPS) Module, Removing the Card Bracket, bottom cover

Get Dell Latitude 12 Rugged Extreme PDF manuals and user guides View all Dell Latitude 12 Rugged Extreme manuals
Add to My Manuals
Save this manual to your list of manuals

Page 25 highlights

Installing the Global Positioning System (GPS) Module 1. Insert the GPS module into its slot and press down the latch to secure it. 2. Connect the cable to the connector on the GPS module. 3. Connect the antenna cable to the GPS module 4. Install: a. bottom cover b. battery 5. Follow the procedures in After Working Inside Your Computer. Removing the Card Bracket 1. Follow the procedures in Before Working Inside Your Computer. 2. Remove: a. battery b. bottom cover c. docking board d. GPS module e. USH board f. MEMS board g. hard drive 3. Unroute the antenna cables by removing the tapes. 4. To disconnect the cables: a. Disconnect the battery cable from the system board and the battery board [1]. b. Disconnect the MEMS cable from the system board [2,3]. 25

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
Installing the Global Positioning System (GPS) Module
1.
Insert the GPS module into its slot and press down the latch to secure it.
2.
Connect the cable to the connector on the GPS module.
3.
Connect the antenna cable to the GPS module
4.
Install:
a.
bottom cover
b.
battery
5.
Follow the procedures in
After Working Inside Your Computer
.
Removing the Card Bracket
1.
Follow the procedures in
Before Working Inside Your Computer
.
2.
Remove:
a.
battery
b.
bottom cover
c.
docking board
d.
GPS module
e.
USH board
f.
MEMS board
g.
hard drive
3.
Unroute the antenna cables by removing the tapes.
4.
To disconnect the cables:
a.
Disconnect the battery cable from the system board and the battery board [1].
b.
Disconnect the MEMS cable from the system board [2,3].
25