Dell Latitude 12 Rugged Extreme Dell 7204Series Owners Manual - Page 29

Installing the Fingerprint Reader, Removing the LED Board

Get Dell Latitude 12 Rugged Extreme PDF manuals and user guides View all Dell Latitude 12 Rugged Extreme manuals
Add to My Manuals
Save this manual to your list of manuals

Page 29 highlights

Installing the Fingerprint Reader 1. Place the fingerprint reader in the slot on the computer chassis. 2. Tighten the screws to secure the fingerprint reader. 3. Install: a. card bracket b. hard drive c. MEMS board d. USH board e. GPS module f. docking board g. bottom cover h. battery 4. Follow the procedures in After Working Inside Your computer. Removing the LED Board 1. Follow the procedures in Before Working Inside Your Computer. 2. Remove: a. battery b. bottom cover c. docking board d. GPS module e. USH board f. MEMS board g. hard drive h. card bracket i. fingerprint reader 3. To remove the LED board: a. Disconnect the LED board from the connector [1,2] b. Remove the screws from the side of the computer chassis [3]. c. Release the LED board [4]. 29

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
Installing the Fingerprint Reader
1.
Place the fingerprint reader in the slot on the computer chassis.
2.
Tighten the screws to secure the fingerprint reader.
3.
Install:
a.
card bracket
b.
hard drive
c.
MEMS board
d.
USH board
e.
GPS module
f.
docking board
g.
bottom cover
h.
battery
4.
Follow the procedures in
After Working Inside Your computer
.
Removing the LED Board
1.
Follow the procedures in
Before Working Inside Your Computer
.
2.
Remove:
a.
battery
b.
bottom cover
c.
docking board
d.
GPS module
e.
USH board
f.
MEMS board
g.
hard drive
h.
card bracket
i.
fingerprint reader
3.
To remove the LED board:
a.
Disconnect the LED board from the connector [1,2]
b.
Remove the screws from the side of the computer chassis [3].
c.
Release the LED board [4].
29